SOURCE: car electrics
you do not need a relay if you are only running it for the trailer lights and DONT cut any wires on you focus loom use what they call scotch locks
SOURCE: i have just fitted a tow bar to my mazda 323f
You'll find what you are looking for on : http://www.volvoclub.org.uk/towbar_electrics.shtml
Hope this helps you out. Cheers.
SOURCE: Fitting a towbar for a caravan with 13pin europlug
black socket, black 7 core wire
pin 1 yellow left indicator
pin 2 blue, rear fog light
pin 3 white earth
pin 4 green right indicator
pin 5 brown right side/tail light
pin 6 red brake lights
pin 7 black left side/tail light
Grey socket grey 7 core wiring
pin 1 yellow, reverse
pin 2 blue, supplementary feed (ignition)
pin 3 white, earth
pin 4 green live feed (battery +)
pin 5 brown not connected
pin 6 red supplementary feed (ignition)
Pin 7 black earth
On the discovery there is a purpose made plug behind the panel on the drivers side rear, behind the rear lamp
i think the relay you have bought is for lamp failure you just need a normal 4 pin 30 amp relay.
Good luck Davelee
SOURCE: Tow bar trailer socket wiring connection point to car wiring?
The connectors for towing wire harnesses on foresters are generally on the passenger side, below the rear taillight inside the cargo space. some require pulling up the foam block that is between the spare tire compartment and the taillight. Check where you replace the tailights from inside the car, if there isn't a matching connector hanging out there, check around the spare tire compartment, see if you can remove the carpeted foam block next to the compartment and find the plug under there.
SOURCE: I am looking for wiring
if you fit the towbar yourself,you can kiss goodbye to your warranty.....peugeot are very strict on this.(assuming you are in Europe.)for USA,things may be different.anyway the wiring loom makers should put a diagram in with the wires....
49 views
Usually answered in minutes!
×