SOURCE: 1992 pontiac bonneville 3.8 v6
It's on the passenger side of the transmission just above where the drive axle goes in. What is wrong with car?
SOURCE: engine swopping
I can't give you direct knowledge, from having personally done this swap before, but I can offer you that the 1990 Cavalier, did have a V6 as an option.
The 3.1 Liter V6 with MultiFuel Injection System.
Of course, you're going to need the ECM, (Computer), and the complete engine wiring harness also.
SOURCE: where are oil and transmission dipsticks located
oil is yellow and the tranny is red and the trany dipstick is the fill. Filter is on the passanger side below the exhaust.
SOURCE: steps required to remove the standard transmission
Make sure you have removed all the bolts ....you will have to pry hard to remove it out .....be careful not to crack the bell housing ..Pry around the bell housing .good luck
SOURCE: need location of HIGH Gear Pressure Switch on gm transmission
Do you have a 1 piece case or does the bell housing unbolt? A 700R4 usually has 3 switches on the back of the valve body.the one closest to the 1-2 accumulator (pass. side rear corner) is the fourth switch. If you have a two piece case, you have a 4L60E,the pressure switch is still on the valve body but it is an assembly,not a single switch.
Testimonial: "thx sorry about 99 it is a 92 but got the ans. "
57 views
Usually answered in minutes!
×