Try using steel wool to clean the contacts for the door. Open the side door. See the brass pins sticking out from the door? Clean those. Then look at the plate with brass squares near the bottom of the door opening, where the brass pins would eventually make contact. Steel wool those too. Might make a couple of little sparks but don't worry. See if that helps.
SOURCE: electric sliding door
pull the radio fuse under the hood in the relay/fuse center. this will clear the memory for the door. the fuse needs to be removed for 20 seconds
SOURCE: sliding door power button doesn't work
locate the relay in the fuse panel under the dash board for the doors... replace it...
Robert
Please rate this solution thanks
SOURCE: 2002 Old Silhouette Driver Power Sliding Door will not open
Look in your owners manual there is a procedure to reset the door controls. If that dosen't work maybe the motor is burnt out, it's in the left rear access panel.
SOURCE: Power door is not delatching
there is a door lock actuator that has failed, it releases the latches so the door can open. you need to remove the door panel. unbolt the window and tape it as to hold the window up then remove the window regulator assembley then unbolt the lock actuator from the back side.
SOURCE: how do you reset power sliding door on 2000 chevy venture
there should be information in your owner manual telling you how to do it if you have miss place your owner manual try this website to see if you can down load one for your car its www.edmunds.com and i hope i was able to help you Michigan Man
145 views
Usually answered in minutes!
×