The clutch has been replaced has less than 2 or 3000 miles on it. alternator and battery are new. had to replace ignition switch bc i lost the key bought key and ignition at auto zone
SOURCE: ignition switch 1994 ranger
If it were me, I'd take the Vin # down to the Dealer and get a key made(and take back the ignition you bought). As far as I know without the original key to allow the release pin to depress, the only possible chance might be to try another Ford key and it may release the ignition basket. Or call a locksmith and he can make a key for probably $50. **Or (ha ha) I could make a copy of my '94 Ranger key and send you a copy ! :>)
SOURCE: need clutch replacement directions for Ford Ranger
Remove drive shaft,remove crossmember under transmission.Remove transmission and diconnect linkage.Remove bell housing,and clutch berring assembely.Remove bolts on pressure plate.Once this is done.Remove fly wheel for machineing.you will need a pilot shaft to alighn clutch assemblely.Possible one will come with new clutch and pressure plate.Reverse assemblely in same order remember to torque all your bolts with torque wrench.Take your time.
SOURCE: How to replace a starter on a 1995 Ford Ranger
you need to check and see if there is voltage at the sylanoid on the passenger fender the little wire marked with an S should have voltage when key is in crank potition with clutch depressed if there is voltage presant then suspect sylanoid if not check fuses and relays
SOURCE: My '98 Ford Taurus won't start
"Security" or Key-shaped light flashes on the dashboard ? Your car might be equipped with an immobilizer. (you can find more information about the immobilizer in your owner's manual). The immobilizer allows the engine to run only if the correct key is used. If your car has an immobilizer, you probably see a "Security" or Key-shaped light coming on on the dashboard every time you turn the ignition ON. If this light is flashing when you turn the ignition ON, it could mean that there is some problem with an immobilizer or the system does not recognize the key. If the immobilizer doesn't recognize the key, the engine wold not start at all, or would start and then die in few seconds.
You can try a spare key, if it won't work, your dealer is the place to call. Sometimes, the key is just need to be reprogrammed.
R
try posting the codes, it sounds like a ECM Engine Control Module(brain) problem.
Testimonial: "thanks thats what i was thinking how do you go about testing it "
146 views
Usually answered in minutes!
×