Programing remote for a 2010 Malibu - Malibu Chevrolet Cars & Trucks

if auto start will need dealer http://www.keyfobprogram.com/2007-chevrolet-malibu-remote-programming or if regular How to Program Chevrolet Malibu Remotes

1. Enter your Malibu and close all the doors.
2. Insert your key into the ignition. Cycle the key to "On," then "Off." ...
3. Press and hold the "Unlock" tab on the driver's side door as you insert and remove the key from the ignition three times.
4. Release the "Unlock" tab. ...
5. Repeat Step 4 for any additional remotes.

Call onstar, they may have remotely upgraded your vehicles program

My guess would be the remote needs replacing. Malibu remotes do not have a very long life span. I've replaced many many many of them for one or two or all of the buttons not working.

Unfortunately your 2009 Chevy Malibu key fob does not have any self programming procedures. You have to have a professional program this key fob to your vehicle. I do have a couple money saving tips for you:

1) Purchase your Malibu key fob online at https://www.keylessentryremotefob.com/Chevrolet-Malibu-Remotes-and-Keys-s/3733.htm

2) Call a locksmith for programming. They are usually more affordable and they come to you.

If your remote is not functioning properly, carry out these steps to reconfigure it:
1. Enter your vehicle and close all doors
2. Put the key in the ignition and switch it ON then put turn it OFF
3. While switching between on and off, press and hold the unlock menu on the driver's side
4. Press and hold the lock and unlock buttons on the remote until your Malibu beeps twice
5. Remove the key from the ignition. It should be reconfigured now.

Hello! Take it to a dealership or an automotive locksmith...They have the proper scan tools to program your remote starter fob...Bring them all if you have more than one...Average cost is under $12...guru...saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

You must take it to the Chevy dealer.

PROGRAMMING
Method One
Sit in driver's seat
Close all doors
Press and HOLD UNLOCK button on door lock switch.
Insert and remove ignition key twice. Do NOT turn ignition switch
Insert ignition key a third time and leave it in the ignition switch. Do NOT turn ignition switch
Release door lock switch.
A chime will sound three times indicating remote programming active
Press and HOLD the LOCK and UNLOCK buttons on each remote for 5 seconds
A chime will sound twice for each remote: indicating successful programming
Remove the key from the ignition switch to exit programming
Method Two
Remotes can be programmed using diagnostic equipment.

take key fob to a cparts store , most have a tester on the counter

Dealer only If you find a different means let me know