The ign. Switch fuse is missing all together in my fuse box is that y nothibg on my car works now if so how much would it cost to replace that

Is the anti-theft light lit on the instrument cluster ? Won't start how ? When you turn the key to start , what happens ? Nothing ? This would be a No crank - no start condition . Now if you turn the key to start and the starter engages and spins the engine and it doesn't start an run , this is a engine cranks no start condition ! Now which is your problem ?

There are two fuse's IGN A fuse 40amp and IGN E fuse 10amp ,both are located in the under hood fuse/relay box . Also there is starter relay located in the same under hood fuse /relay box . There also is a crank fuse 10amp in the under hood fuse box . Besides the fuse's and relay ,the ignition switch or the PNP - park neutral position switch could be bad . Testing the whole starter circuit should be done ! How to voltage drop test starter motor circuit

check the blower relay sounds like sticking contacts

dead engine,
do head lamps work?
on a dead car, dead engine, all power comes from the main car battery. and all power feeds are fused.
if fuses blow, no power to that feed.
if the battery is dead so will be the head lamps and hand lamps
do not take a key top work (a safety feature)
this car is toyota corolla. (with geo stickers)
how do you know power is missing from F10?
you used a voltmeter there? or test lamp? how>?
there were 2 engines, 4A and 7AFE engines.
ill guess and answer for 4AFE engine
Fuse 10 is not a number its the current rating of the fuse.
and is maked (you didnt show a photo of fuse, nor where it is)
is marked IGN
now ill answer with the schematic. (makes it 10x more easy)
now power feeds IGN fuse, from the key switch
if that switch works the power come to it from
AM2 fuse
If AM2 is dead then the battery is dead. or
the battery ground is bad.
or the battery lugs are rusty
or the battery is only discharged, so charge it.
or jumper cable start car like you see the AAA tow truck man do.

You have a direct short to ground on that power feed circuit . You need to find a power distribution diagram to see what all gets is power from that fuse . Isolate the circuits till the fuse doesn't blow any more , then trace out that circuit that blows the fuse .

Which Ignition fuse ? Which fuse box is it in ? under hood , passenger compartment ?
IGN A
40A
Ignition Switch RUN, START, RUN/START/ACCY
IGN B
40A
Ignition Switch RUN/ACC, RUN/START
Could be ignition switch problem , Chevy has had problems with them .

I would have to say the fuse box. Check for any blown fuses.

Main relay ? where are you missing power ? In the under hood fuse / relay box check IGN 1 an IGN 2 fuses both 50 amp .they supply power to most of the vehicle !

S type jaag ?? yes immobilisor ,disconnect battery join leads together ,leave for ten mins while you have a cuppa then reconnect battery and it will start .leads must be joined though not just disconnected

it may help to tell what car you have. Hazards ALWAYS work, no matter if the ign switch is on or off. maybe the switch is bad.

replace the ign electrical switch

Hi...
I read your problem.
Is there a few step to diagnostic or try to fix your car.

Follow this simple steps.
Inspect the RALAY " Starter relay # 47. or interchange with other one just for testing.
1- Check the Fuse " IGN E Fuse number 22 " 10amp. on under hood fuse BOX fron Neutro swicth
And power to the power to the Neutro safetly switch.
2-- Check the Fuse " CRANK fuse # 17 10amp. Under hood fuse box. 12v. from Ignition switch
3- check the fuse " IGN A fuse # 34 40 amp. under hodd fuse box. Constant 12v. to relay.
With ignition switch in ON position.
Crank Fuse only when you try to start. If no power 12v. come when trying to start.
REmove the steering column covers. to get axces to the IGNITION SWITCH.
Trying to start check if 12 v on the YELLOW wire exist. if not. Check if there a 12v on the RED wire
If not Inspect FUSE # 34.
But if there a power on the red wire But not ON yellow wire Trying to start.
Just REPLACE THE IGNITION SWITCH. Electrical part.

Check the NEUTRO SAFETLY SWITCH. connector under the car. Repair as need.
CHeck the BACK-UP lights, some times come damaged making a short on the Neutro safetly switch. ...

OK.. I hope this help on your problem.
If you need more information letme know.

I'm a Mechanic and have all the information for repair vehicles.

Thank you for use fixya....