I need to know where the cruise control speed sensor and or relay are on a 1994 Eclipse GS manual 2.0 non turbo

SOURCE: crankshaft position sensor location

if u pull the battery and battery tray u can easily reach this

SOURCE: crankshaft position sensor location

Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.

SOURCE: 5 speed manual transmission. reverse will not engage

I had the same problem. A spring in the gear change selector had broken making it impossible to get into reverse and very difficult into first to fifth. Simple repair. Might be similar to your problem

SOURCE: Adjustment Specification for the IAC Valve on a

This item is a self learning part. You will need to put the car in gear and have the emergency brake on. Also have your left foot on the brake pedal for the front brakes. Rev the RPMs up to 1200 & no more and hold it there for 5 minutes. That will set the IAC to the setting needed to idle. It is a computerized controlled item and the feature here presented to you will set the learning code to the computer

Testimonial: "Thanks for the info on this problem that I'm having. I will give it a try and then let you know what happens from there. sraven08"

SOURCE: where is the map sensor

Under hood, center, front engine area, mounted on driver side lower front of engine