SOURCE: remote key fob will not work-battery replaced
VW/AUDI/SEAT/SKODA
Remote Control Programming (1997 ON)
Procedure
1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the Drivers door using a second
key.
3. Using the remote control press the Unlock button once, and the horn
will sound once.
4. Wait 6 seconds and press the unlock button once to activate the coding
procedure. The remote control will now be programmed.
NOTE : When performing programming on additional remotes the procedure
is the same, except you press the unlock button 2, 3 or 4 times for the
different remote.
For example : If programming 2 remotes press the unlock button twice with
a 1 second interval between each press, repeat for 3 and 4 remotes.
5. Switch Ignition OFF.
6. Remove key from ignition and check for operation.
7. The coding procedure can be repeated up to 4 times for additional remotes.
8. The ignition must be switched OFF between programming each remote
control.
Remote Control Erasing (1997 ON)
Procedure
1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the Drivers door using a second
key.
3. Press the remote control unlock button 5 times in 1 second intervals.
A short horn will sound.
4. Wait 6 seconds and press the unlock button once to activate memory
erase.
5. Switch ignition OFF, all remotes are now erased.
SOURCE: 2004 Toyota Camry key fob programation
sit in car all doors closed put key in ignition and turn from OFF to ACC 3 times as fast as you can leaving it in ACC on the last cycle then press your remote button. your blinkers should flash to tell you this has worked.... may take you a couple of tries to get it!!
SOURCE: how do you re-link the key fob to the car after
Try this,,turn the key on ,wait 10 minutes,then turn the key off,then right back on,do this three times,a total of 30 minutes,this should reset the key fob,if this is the problem.
SOURCE: Porsche 2000 911 Carrera. Key fob problem
each vehicle is different put the key in the ign. turn key on press door lock/unlock at the same timehold button for 10 sec see if any lights on the dash inst. panel blink if they do that means that the key fob was programmed to your vehicle i recommend a new key fob this will give you definative instructions on how to reprogram your fob
SOURCE: How do u program a new key fob for a 2004 chevy
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the DOOR unlock switch.
While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds , the doors will lock and unlock to confirm the programming of that transmitter.
Repeat the previous step to program up to four transmitters.
Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation
How to Program a Key FOB for the Chevy ... your Chevy, if you obtain new or replacement keys they will need programming to work with ... How Do I Program MyKey Fob? ...
KEYFOB PROGRAMMING
If
the remote s faulty then key fob will not get programmed.
Insert
the key in ignition. Turn the key to on position, and cycle the key three times
off-on-off-on-off-on. Then with the key fob remote select your remote and then
try to operate the vehicle with remote.
These
are just the basic procedure, but sometimes it will not help.
On
that case dealer is the only option.
---------
There
are few much related troubleshooting links mentioned below for remote key fob reprogramming.
I suggest you to go through the list and click the link below to go through its
details and procedure: -------
http://whatisbyme.blogspot.in/2012/05/2009-toyota-highlander-smart-key-not.html
----------
-----------
http://whoisbyme.blogspot.in/2012/07/pin-that-holds-flick-key-part-to-key-fob.html
-------------
http://technoanswers.blogspot.in/2012/04/2006-toyota-hilux-programming-new-key.html
----------
http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html
----------
http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html
----------
http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
-----------
http://technoanswers.blogspot.com/2011/12/audi-a8-key-fob-programming.html
----------------
http://technoanswers.blogspot.com/2011/12/olds-aurora-key-fob-reprogramming.html
-------------
http://technoanswers.blogspot.com/2011/12/buick-lesabre-key-fob-reprogramming.html
---------------
http://technoanswers.blogspot.in/2012/01/keyfob-remote-not-working-on-2003-ford.html
-----------
http://technoanswers.blogspot.in/2012/02/key-will-open-doors-but-not-start-on.html
------------
-----------
http://technoanswers.blogspot.in/2012/02/key-fob-will-not-lock-and-unlock-doors.html
-------------
-----------
-----------
http://technoanswers.blogspot.in/2012/02/theft-indicator-not-letting-car-to.html
-------------
http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html
--------------
These
details will help.
Thanks.
750 views
Usually answered in minutes!
×