SOURCE: Jeep grand cherokee 247 Transfer case Interchange ?
if the shifter is the same and they have the same front driveshaft then yes
SOURCE: window motor replace 2001 jeep grand cherokee
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
SOURCE: where to replace coolant temp sensor for 1998 grand jeep cherokee
Check this image...
...in the Section ZJ-Secc-8D-Ignition-Systems (page 5, fig. 10 and 11).
Good luck.
SOURCE: 2001 Jeep grand cherokee motor knock 4.7 motor
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Testimonial: "Thanks"
SOURCE: change a headlight assembly Jeep Grand Cherokee
Just need take off the screws; for details check the graphics and ilustrations in the Jeep ZJ Grand Cherokee Service Manual
Hope helps (remember rated this) Good luck..
252 views
Usually answered in minutes!
×