Crankshaft position sensor location 2004 5 speed manual non turbo pt cruiser

Question edited for clarity and maker.
Question moved to the category.

Crankshaft Position Sensor

https://www.google.com/search?q=2005+Chrysler+PT+Cruiser+2.4+Turbo+GT.+code+P0339

..

See the link.
2005 pt cruiser crankshaft position sensor removal and replacement

P0344 CHRYSLER - Camshaft Position Sensor Intermittent Interruption Bank 1 Sensor 1
Possible causes - Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty starter motor
- Starting system circuit

REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION).

Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.

Its located on the engine block usually the front

The camshaft position sensor on an 04 pt is located on the right side of the engine, towards the top (looking at it from the front), directly in back behind the oil dipstick on a non-turbo

Had this problem. The crankshaft position sensor (on 2003 non-turbo) is located directly under the starter. The Haynes and Chilton books will tell you the complete opposite. They state that it is located near the alternator. WRONG. Oh, it is really a pain to get to FYI.

IT IS LOCATED IN THE BLOCK BELOW THE STARTER..UNPLUG CONNECTOR AND 1 BOLT..IT MAY BE STUCK IN BLOCK..SPRAY WITH PENETRATING OIL..MOVE BACK AND FORTH PULL OUT OF BLOCK

You may sneak it out with small fingers with out pulling out the starter.

If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.


Please rate this a fixya

It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.