SOURCE: would like to see a diagram of where exactly the
Which engine?? V6 or the 2.4I? The V6 CKP is in the engine block near the flywheel side of the engine (behind and lower right of the exhaust manifold nearest the radiator) A 10mm bolt holds it in place. On the 2.4 4cylinder, the sensor is at the front of the engine behind the Timing Belt cover at the crank shaft. To replace it, you have to remove the timing belt, but you also need to know some technical things to reinstall the belt to be sure you are installing it correctly. Go to http://www.hmaservice.com/ and register. You'll then have access to lots of technical info and manuals, wiring diagrams, etc. about your vehicle.
SOURCE: 2003 Hyundai Santa Fe FWD transmission slippage
try resetting adaptive values to see if that helps. remove both battery cable terminals and hold them together for about 30 seconds to discharge all power. reconnect and drive.
SOURCE: where is the trans speed shaft sensor on a 2001 hyundia santa fe?
There are two speed sensors, Input sensor is located on top of the bell house. Output sensor is located on the firewall side of the bell house.
SOURCE: 2004 Hyundai Santa Fe 3.5L V6 What all do I
Removal & Installation
To install:
Crankshaft Position Sensor
The crankshaft position sensor is located at the front of the engine near the timing belt.
SOURCE: 2004 Hyundai Santa Fe 2.7 all wheel. Crank sensor
Hi
On the 2.7 engine it is located beside the starter. You will have to remove the starters heat shield to gain excess to the crank sensor.
58 views
Usually answered in minutes!
×