Oil filter location on a 2016 Chevy Cruze premeir

Hello Joe

Here is information and videos for changing the Thermostat Housing.

https://www.google.com/search?q=2014+Chevrolet+Cruze+1.8+litre+replace+new+thermostat+housing

The Oil Cooler Leak is a known issue.

https://www.google.com/search?q=Chevy+Cruze+stop+the+leak+around+the+oil+cooler+pipe

Merry Christmas Joe

..

These things are now a function of the Body Control Module. There are a number of fuses with that designation. Check them with the probes of a multimeter set to ohms using the contacts in the top of the fuse.

Fuse Box Diagram Chevrolet Cruze (J400; 2016-2019..)

https://fuse-box.info > chevrolet > chevrolet-cruze-j400...
Here you will find fuse box diagrams of Chevrolet Cruze 2016, 2017, 2018 and 2019, get information about the location of the fuse panels inside the car, ...

..

Bingo correct when engine gets a few miles up the seals go hard.Allows oil to seep into water.Bad design.Barinas.Astras.Have fun.

Most Chevy products have the fuel filter under the drivers seat under the car on the frame rail.

if gas in tank with fuel pump if diesel need to drop passengers side protection cover under vehicle to expose filter container Cruze Diesel Fuel Filter Replacement

It's built in to the fuel pump assembly located in the fuel tank.

Set park brake..,wear safety glasses.., Raise truck front suspension and place on strong Jack stands for space..Or else crawl under it...The sensor you speak of is normally mounted above the oil pan in the engine block...The oil pressure sensor is normally at the center of block just above the oil pan..However there should also be a crank sensor but it will not be in the center of block....It should be at the rear of engine..cam sensor should be at front of engine...Look at passenger side of engine..

The fuel filter on the Cruze is underneath the car on the passenger side. To access it:
• Remove the aerodynamic housing
• Keeep an oil pan underneath to catch the residual fuel
• Use a wrench to open up the filter, and once you see the O ring, start unwinding by hand
• A housing will drop out with the fuel filter-put some pressure, and you can remove the fuel filter.

Where is the relay module 45 and 46 located on my 2011 chevy cruze

It is probably the change oil soon light. It needs to be reset manually at every oil change. Here is how:
http://oilresetpro.com/how-to-reset-oil-maintenance-life-on-2011-2013-chevy-cruze/

There is also a mobile app for your phone that has all the oil maintenance light reset procedures from these guys. Hope this helps!