Install and remover alternator on2005 dodge grand caravan 3.3 engine

SOURCE: installing an alternator belt on a 1991 dodge grand caravan

for the 91 caravan as you requested , there is 3 engine choices , here is all 3 . cheers .

Mike Butler

• 6674 Answers
• Posted on Mar 01, 2009

SOURCE: need procedure to remove/replace radiator on 01 Dodge Grand Carva

This Link is for R&R rad fan assy, but once your there, the rad should be pretty obvious, what else needs to be done. Fan has to come off first anyway.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528021e5b1

SOURCE: Dodge 2005 Grand Caravan water Pump replacement

JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.

GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.

Automotive repair and diagnoses

• 8 Answers
• Posted on Sep 12, 2009

SOURCE: how to install egr valve on 2006 dodge grand

You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.

SOURCE: 2004 Dodge Grand Caravan engine light on, missfire

That is a code for the secondary (spark) circuit on cylinder number 3. It is usually caused by a bad connection between the coil and the plug (take the coil off the plug and check for moisture in the boot). If not, it might be a bad coil...