This is on a 2008 Chrysler 300c
SOURCE: Left rear brake light stopped working but bulb and fuses are OK.
take the bulb back out have someone sit in car apply brake get your self a circuit tester and check to see if this circuit is carrying efficient 12 volt current! some times in cold weather these bulbs get hot with long period of breaking and when released condensate and rust begins and you get what you have perhaps bad socket! this would be a ideal location to begin and probably end,
SOURCE: 2005 chrysler 300c 5.7l v8 hemi.........over heating
The fans are turned on by the PCM, if the PCM is not telling the fans to turn on, they won't even if everything tests fine.
2005 Chrysler 300 V8-5.7L VIN H
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
ENGINE COOLANT TEMP SENSOR
REMOVAL
The Engine Coolant Temperature (ECT) sensor (3) on the 5.7L engine is located under the air conditioning compressor. It is installed into a water jacket at the front of the cylinder block.
WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE INJURY BY SCALDING. COOLING SYSTEM MUST BE
PARTIALLY DRAINED BEFORE REMOVING THE COOLANT TEMPERATURE SENSOR.
1. Partially drain the cooling system.
2. Remove accessory drive belt.
3. Carefully unbolt air conditioning compressor from front of engine. Do not disconnect any A/C hoses from compressor. Temporarily support
compressor to gain access to ECT sensor (3).
4. Disconnect electrical connector (2) from sensor (3).
5. Remove sensor (3) from cylinder block.
INSTALLATION
1. Apply thread sealant to sensor threads.
2. Install ECT sensor (3) to engine.
3. Tighten sensor to 11 Nm (97.3 inch lbs.) torque.
4. Connect electrical connector (2) to ECT sensor (3).
5. Fill the cooling system.
SOURCE: how do i program the garage door opener on my 2008
This issue resolves at the garage opener, itself. Later model openers use rolling code technology, which moves access code with each transmitter, on each use...
Read the directions on your opener (yes get a ladder and climb up there..) essentially the methodology is typically press button on new transmitter, and hold, then press programming button on the opener, and when the lights flash, release both, then test remote...
Read directions on your opener, as a very similar process EXCLUDES all prior transmitters...
Doc.
SOURCE: back up warning system keeps turning off
it will need to be scanned, sound like one of your sensors isn't working, a scan should tell which one.
Testimonial: "Will take to shop --- would you recommend dealer or local Firestone shop?"
SOURCE: my chrysler 300c will not shift from park
With out being able to see it sounds like you have a misadjusted or broken park lock cable. there is a cable that locks shifter in park unless Brake pedal is depressed. So if you are pressing the brake and can not shift into a gear. that would be the first place I would check
45 views
Usually answered in minutes!
×