Here Is The U1403 Code But If Your Ac Is Blowing Hot Air ? Is It Low Coolant Issue Or? (More Info Please!!)
U1403-IMPLAUSIBLE FUEL LEVEL SIGNAL
The fuel level message that the PCM is receiving is implausible. The circuit is continuously monitored.
Possible Causes
CAN B OPEN OR SHORTED
CLUSTER MODULE
FRONT CONTROL MODULE
PCM
Theory of Operation
The Front Control Module receives a fuel level signal over CAN B from the Cluster Module. Once the message is received from the FCM, it passages the fuel level message via CAN C to the PCM.
U1411-IMPLAUSIBLE FUEL VOLUME SIGNAL RECEIVED
The fuel volume message that the PCM is receiving is implausible. The circuit is continuously monitored.
Possible Causes
CAN B OPEN OR SHORTED
CLUSTER MODULE
FRONT CONTROL MODULE
PCM
Theory of Operation
The Front Control Module receives a fuel volume signal over CAN B from the Cluster Module. Once the message is received from the FCM, it passages the fuel level message via CAN C to the PCM.
pull fuse 11 in IPM (underhood fuse box) for 30 seconds to clear codes.
SOURCE: 2005 Dodge Magnum w/out hemi stalling
I have a 2005 Magnum and was also having this problem. Stalled out a few times and continued to idle rough and feel like it was going to die when I would slow down. At times it would feel like I would get a hesitation and then a surge. Engine light would go on for a day or so, then go out for a few days. First time I took it in, the dealership told me that it was a broken seal (I don't know where), but they replaced it and it continued to happen. The second time I took it to a mom & pop shop, and they told me that it was the oxygen sensor/altimeter, replaced it (only a $35 part), and I haven't had a problem since. That was 6 months ago. Hope this helps...
SOURCE: 05 Dodge Magnum 3.5L-temp gauge not working.
the whole dash unit iam afraid ,or fit a stand alone add on fuel temp gauge
SOURCE: MY SUNROOF IS STUCK OPEN IN MY 05 DODGE MAGNUM
Hello. Begin by checking the fuse that controls the sunroof, just look in your owner manual under fuses and you will find a diagram and location for where to look. If the fuse is bad, replace it with a new one of the exact same amperage. Also, use a can of pressurized air [like a computer duster] and clean the rocker switch that controls your sunroof, try to blow air behind it on both sides. Finally just rock that switch back and forth rapidly several times which may break the motor free so it will work again. Regards, Joe
PS please rate my answer. Thank you.
SOURCE: Transmission will not shift first
CODE P2767 - TRANSMISSION INPUT SHAFT SPEED SENSOR TURBINE SHAFT SPEED TSS SENSOR B NO SIGNAL.POSSIBLE CAUSE SHORT IN WIRE CONNECTOR OR FAULTY TSS SENSOR OR TURBINE SPEED SHAFT SENSOR.
5,288 views
Usually answered in minutes!
×