Where is my fuel pressure regulator located on my 1996 Chrysler Town and country

Gary Queen

• 85 Answers
• Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.

SOURCE: need the location of the fuel filter fora 1996

It will either be inside the gas tank (real pain) or it'll be in front of the gas tank recessed into the frame.

SOURCE: need location of crank sensor

You did not mention the engine size you have, but the sensor is mounted on the trans housing and will look like this on a 3.8 liter engine.

ZJ Limited

• 17989 Answers
• Posted on Aug 08, 2010

SOURCE: LOCATION OF THE ECM ON

On 1996 Chrysler Truck Town & Country 2WD 3.8L MFI 6cyl the Engine Control Computer is located under hood, driver side, front side of strut tower, mounted on wheelwell.

Hope this help you (remember rated this asnwer).

Marvin

• 85242 Answers
• Posted on Sep 21, 2010

SOURCE: IOD fuse location in a 1996 Chrysler town and

It's in the fuse box under the hood by the battery. Open the box. It's the one at the front and farthest to the driver's side. Should be a yellow 20 amp fuse. Removing it will kill the radio, navigation and multi disc player.