Is 2008 hhr heater blend door and actuator control arm made together? Actuator is OK. The part that's actually moves the door is broke . Was wondering if entire door has be replaced or just the extension that the actually turns can be replaced?
SOURCE: new blend door actuator doesnt operate
had this problem before... recheck part#....is it for EATC or MANUAL...??? eatc on a manual will only go to half way...sounds like they gave you the wrong part....its a pain to replace wasn't it.....hope this helped you...GL
SOURCE: blend door actuator needs replacing does the
no it doesnt ... check out heatertreaters.net if you have to replace the blend doors .... but the actuator is directly behind the glove box...remove the glove box take out 3 screws and remove actuator and replace.....waa laa
SOURCE: how to replace blend door actuator in a ford
I recently did mine, I hear you can do it without taking the entire dash apart but I had no luck with it myself. I have to get ready for work but, on mine it was located down and to the left of the radio. its a white box...are you hearing a clicking noise or something? I had to roll the entire dash back and it was still a major pain getting it out.
SOURCE: What do I have to remove to access blend door actuator
very lenghty process. too long to describe here....go to Bonneville Forums read the text and follow linked there at the bottom....very good and detailed....I'm doing that right now,,,,it is a bugger,
Fig. Remove the floor air outlet duct extension (1) from the floor duct (2)
Disconnect the electrical connection at the blend door actuator (#10 in pic below).
Fig. Blend door actuator and related components
Remove the blend door actuator mounting screws from the HVAC module.
Remove the blend door actuator as an assembly with the actuator cam.
Fig. Remove the blend door actuator mounting screws from the HVAC module
To install:
Picture of actuator:
1,059 views
Usually answered in minutes!
×