Drivers side
First you need a 10mm socket and Ratchet take the two bolts off of the top of the headlight and after those come out you can pull the headlight away from the car a little bit and unplug the plug being sure not to break the little tab that holds it on tightly then turn the ring that surround the bulb that should pull right out then the bulb will pull out itself when you're installing the bulb do not touch the glass of that bulb then reverse the order of taking the headlight out .
SOURCE: Driver side headlight bulbs burned out on 2003 VW Golf
There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in. (I say clamps, but they're more like glorified paper clips on either side of the fixture.) Press in on each side, pushing the clamps towards each other and pull the fixture out.
SOURCE: need to replace headlight bulb
they are replaced from inside the engine compartment... you may have to remove the battery if it's on that side... do not touch the bulb as that will shorten it's life
Robert
Please take a moment to rate this solution... thanks
SOURCE: Need to replace the bulb on 2000 grand am gt
You should be able to replace the bulb from the rear of the light from inside the engine compartment. I is a small bulb unlike the hole light as in older cars. You must pull the plug connector off the back of the bulb than un-clip the heavy wire spring retainer and pull the bulb back. Try to remember the position of the metal positioning tabs. It's not a bad idea to take it with you when you go to buy a replacement as well as the car info. The new bulb must be handled with extreme care. At no time can you touch the glass bulb part. The oils from you had will significantly reduce the bulbs life. Now just slide the bulb back into the hole noting that there are three tabs of different size to insure the proper position of the bulb to get the correct light pattern on the road. Good luck.
SOURCE: 2003 Grand Prix GT - power windows
NEED TO CHECK ,MAIN POWER SOURCE ON DRIVERS DOOR OR MAIN CONTROL
SOURCE: how do you get to the headlight to replace the low
You will need to open up hood, reach inside by headlight, FInd the plastic ring and turn counter-clockwise and then remove it. Then take bulb and harness and turn and pull that out.
Unclip the harness from bulb.
38 views
Usually answered in minutes!
×