Did both cam sensors and crank sensor reflashed ecm and pcm engine is hard starting
SOURCE: HELP
near the throttle body part there is a electronic idle control valve either this control valve is defect or there is a leak between the body and the valve.
regards Sam (holland Europe)
SOURCE: 1999 Jeep Grand Cherokee Laredo won't run
if ur jeep has central lockin lock it and then unlock it ..........she might b sucking air inn
SOURCE: 2001 jeep grand cherokee no start, no cam signal or ASD control from pcm
IF YOU PULL OUT CAM SENSOR YOU HAVE TO PUT A TOOTH PICK IN THE TWO HOLES ON THE TOP AND THEN PUT IT BACK IN AND FACE IT TO THE BACK OF THE ENGINE.KING OF 4.0
SOURCE: WHERE IS THE CAM POSITION SENSOR LOCATED ON A 2004 NISSAN MAXIMA
WHEN YOU STAND ON THE FRONT OF THE CAR YOU ONE IS RIGHT BELOW OF THE INTAKE WHICH IS BANK 2 OR THE ONE CLOSE TO FIREWALL , BANK 1 ONE IS ON SAME SIDE NEXT TO THE RADIATOR BUT THEY BOTH ON THE CAM RIGHT SIDE OF THE ENGINE, THE EASIEST WAY TO IDENTIFY THEM IS THAT THEIR CONNECTOR IS GREEN, ONCE YOU LOCATE THEM THE CLIP NEEDS TO BE PUSHED DOWN TOWARD THE SENSOR FOR THE CONNECTOR TO BE RELEASED, ONCE YOU REMOVE THE CONNECTOR THERE WILL BE ONLY A 10MM SCREW HOLDING THE SENSOR PULL IT OUT , THE SAME SETTING THE NEW ONE PUSH IT ALL THE WAY IN , THIGHT THE 10MM SCREW, CONNECT IT BACK AND YOU'RE DONE,BUT FOR THE ONE ON THE BACK SOMETIMES MIGHT BE NECESARY FOR YOU TO TAKE THE INTAKE OFF....HOPEFULLY IS NOT YOUR CASE....
Good luck!!! and if you need the crank for hard starting on hot/warm, it is located on the botton middle section on the transmission is the only cable that goes down to a small piece of metal and it is held by a 10mm screw only to protect the sensor, you will se the sensor once you remove that small about 6-8 inches piece of metal. Then you'll be able to unescrew the 10mm screw that holds the crank position sensor. when you pull it off you'll be able to see the fly wheel inside the transmission...
you all enjoy your rides out htere!!!
SOURCE: code p0336 starts hard tach wont work obd11 07 cobalt
P0336 means Crankshaft Position Sensor A Circuit Range/Performance. Try replacing the crank sensor next.
http://www.check-engine-light.com
189 views
Usually answered in minutes!
×