To access the wiper, remove plastic cover. Remove nut on wiper arm. Carefully pull off wiper arm. Replace with new wiper assembly. Remember where wiper arm was and reposition it. Put nut on and tighten. Do not over tighten. put plastic cover on and your done.
SOURCE: How to remove rear wiper arm
Remove the nut holding the arm. Should be able to lift up on the arm and loosen the joint at the motor.
SOURCE: removal of broken rear wiper arm. removed nut but
After removing the nut turn the arm up and wiggle it back and forth while pulling it will come off.
Testimonial: "Thank you for the advice. You saved me labor cost at the dealer and waiting around for the repair."
SOURCE: Can't remove rear wiper to replace on 96 caravan
Lift wiper arm from rear window. then release latch that holds the blade to the wiper arm.( It's small tab)
SOURCE: replace the rear wiper arm shaft
There is a plastic cover that pops off at the pivot end of the wiper arm. pulling up on this with a hook of some kind from the furthest end should release it. Under it you will find a nut that holds the wiper arm to the shaft. It's quite common for the nut to come loose and the shaft spins without moving the arm. Try tightening this nut (with the ignition on, be sure the wiper motor is off, then turn off ignition and put the wiper arm in the parked position). This is a common problem if you've ever tried to turn on the wiper when it was frozen to the glass.
SOURCE: replace rear wiper arm
there is a cover at the base lift it up and then you have a nut. 10mm remove this and pull off the arm. sometime they get stuck and you will have to pry it up.
to break it free, but with the right amount of wiggling, it will
disengage.
to break it free, but with the right amount of wiggling, it will
disengage.
to break it free, but with the right amount of wiggling, it will
disengage.
to break it free, but with the right amount of wiggling, it will
disengage.
605 views
Usually answered in minutes!
×