How do I replace the rear left tail light cover of Chevrolet Corsa bakkie 2011 model?

Joseph Reichwein

• 71 Answers
• Posted on Nov 10, 2008

SOURCE: 2006 Chevy Trailblazer Tail Lights

There was a recall on this, take to the dealer and they will replace the whole socket on this.

SOURCE: 2003 Toyota Sienna - Need to replace left rear brake light

Hi -
I just replaced my left rear brake light on my 2005 Sienna. I followed the manual directions and removed the two metal bolts from the tail light cover. However the assembly did not come off. I could open it a little and it appeared to be bolted from the inside. I looked online but didn't find an answer. I had already gotten pulled over and I didn't want to go to the dealer so I pulled on the assembly a little harder applying even pressure to the top and the bottom and it popped loose. I didn't yank it. There are two metal pegs that have a little lip on them and thats where you are getting the resistance. Hope this helps.

SOURCE: left rear tail lights/ blinker will not come on

Blinker too fast, the same side blinker light bulb on the front (or back) is burned. Check the fuses for the rear lights. You might have a light bulb filament stuck.

SOURCE: NEED TO REPLACE A TAIL LIGHT BULB IN A 2005 CHEVROLET IMPALA

and Repair Notes TAIL LAMP REPLACEMENT REMOVAL PROCEDURE Open the rear compartment. Remove wingnut and pull back the rear compartment trim panel from the tail lamp. Remove the wingnuts from the tail lamp. Remove the tail lamp from the rear body panel. Disconnect the electrical connector from the tail lamp. Remove the tail lamp socket, turning counterclockwise. Remove the bulb from the tail lamp socket. Remove the sidemarker lamp socket, turning counterclockwise. Remove the bulb from the sidemarker lamp socket. INSTALLATION PROCEDURE Install the bulb to the tail lamp socket. Install the bulb to the sidemarker lamp socket. Install the sidemarker lamp socket, turning clockwise. Install the tail lamp socket, turning clockwise. Connect the electrical connector to the tail lamp. Install the tail lamp to the rear body panel. Install the wingnuts to the tail lamp. Pull back the rear compartment trim panel to the tail lamp and install the wingnut. Close the rear compartment.

SOURCE: 2002 Toyota Highlander Cracked Tail Light

Inside your trunk on either side of your tailgate are panels that allow you access to your taillights....I'll add more later.