Hello, crank position sensor located at the 2 o`clock position hidden behind timing cover and crank shaft pulley. If you look closely in well lit area or use a flashlight you can follow the (CCPS) harness down the right hand side of timing cover to where it goes into lower timing cover on lower right hand side of crank shaft pulley. It can be replaced with out removing timing belt. Please note if the 60,000 miles heavy service interval for timing belt is needed and water pump condition should be observed when repairing the crank position sensor.
SOURCE: crankshaft position sensor location
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
SOURCE: location of crank position sensor 2003 santa fe 4
hi the sensor is in with the timing belt. You will have to remove the timing belt cover and belt to put a new one in. You will also see a small gold metal rotor that spins on this sensor also replace that or it will trash the new sensor.
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: Location of camshaft position sensor on 2004
On 1999 and later 2.4L SOHC engines it is located on the left end of the cylinder head (opposite end of the engine from the timing belt)
SOURCE: Change a crankshaft position sensor on a 2000 eclipse
Is this a V6 or 4cyl???>>>(V6) This requires removing the Harmonic balancer (crankshaft pulley). Remove (R) front wheel, remove engine splash Guard, Remove crank pulley, remove lower timing belt cover. The Crank sensor is located behind the crank shaft pulley!! I highly recommend having this done by a certified tech, requires special tools. Hopefully this helps!!
2,412 views
Usually answered in minutes!
×