SOURCE: Cam Shaft Sensor Problems
Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.
SOURCE: I'm looking for wiring schematics
in the library there are mitchell books in the reference section. you cannot check them out but they come apart down to a single sheet for copying. they are excellent diagrams and im sure they will have your vehicle. they also contain some emissions related vacuum diagrams.
SOURCE: remove the rear brake drum on 2004 Dodge Caraven
No just make sure your emergency cable is off and take a large hammer an hit it around the edge or corner lightly and spin at the same time also try pulling with your other hand as you spin this is a technique all mechanics use its very unlikely that you will have to loosen up the shoes with a brake spoon.REMEMBER THE OUTER ROUNDED EDGE ONLY WHERE ITS THE THICKIST.
SOURCE: 2005 dodge grand caravan getting code p0406
3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .
SOURCE: P2097 Error code in 2006 Dodge Grand Caravan, which O2 Sensor?
The one before the catalytic, on the side where cylinder # 1 is at. close to the exhaust mag.
272 views
Usually answered in minutes!
×