Adjustment headlights 1994 Silverado - Silverado Chevrolet Cars & Trucks

How to Adjust Headlights - 2014 GMC Sierra - YouTube

? 2:26
www.youtube.com/watch?v=FFMjHoBcCW8
Aug 29, 2015 - Uploaded by fondupot
Short video showing how to adjust headlights up and down on a 2014 GMC Sierra. This will be similar on a ...

how do you adjust headlights on a 2013 silverado? ' Yahoo Answers

https://answers.yahoo.com/question/index?...20130125051810AAg9SM..
Jan 25, 2013 - There's two adjustment up around your headlight, one is for side to side and the other one is for up and down. Be on level ground and point at a ..

Your vehicle only has up/down adjustment as far as I know. You need a hex head to adjust them. A 7mm will work in a pinch. The adjuster is in the center of the headlight bracket just below the top of the bracket. You will see about a one inch hole with a recessed hex head for each light.

There are screws in plain site to remove the chrome trim

No cables involved ,just headlamp adjustment screws

No. Dash lights being out could be a bad headlight switch, since the dash lights are routed through the headlight switch, not the dimmer switch. Park and tail lights also controlled by the headlight switch.

There are two adjustment screws at the top of each headlight. They are visible when the hood is up. Use an Allen wrench (hex) of the proper size to turn one screw to adjust the height and the other for lateral adjustment.
It is best to position the vehicle on a level surface a facing a wall or garage door. The vehicle can be about 8 feet from the wall during adjustment.
Adjust the light left/right and up/down with those adjustment screws. The head lights should point somewhat straight ahead at the same height as the headlight itself and the same distance apart.
After adjustment, park the car on the street at night, turn light son and stand about 50 feet form the vehicle to see if either light (low beams) seem too high. It would appear brighter if it is too high, dimmer if it is too low.

Raise the hood and look for two small screws on the headlight, one is closer to the radiator for side to side adjustment and the other is for up and down adjustment.

try removing the black cover that wraps out from the door to the mirror just be carefull.....plastic ****.

This is the same for the pick up as is the Trooper:

Aerodynamic Type


Replacing a headlamp bulb—1994 Trooper shown



Replacing a headlamp bulb—1994 Trooper shown

1. Disconnect the negative (−) battery cable.
   
2. Open the hood and disconnect the headlight bulb electrical connector.
   
3. There are two possible designs. For the first design, turn the bulb to remove it from the housing, for the second unscrew the retaining cap and remove the bulb.
   
   WARNING Do not touch the glass portion of the halogen bulb. Any contamination on the bulb may cause the bulb to burst when turned ON. If the bulb is contaminated, clean the glass portion with rubbing alcohol.
   
   
4. Hold the bulb by the plastic portion only. Install the bulb and connect the wiring harness. Make sure the sealing ring is in place.
   

Non-Aerodynamic




Replacing a sealed beam headlamp—1990 Amigo shown

1. Disconnect the negative (−) battery cable.
   
2. Remove the front grille and/or headlight bezel.
   
3. Remove the headlight bulb retaining rim, headlight and disconnect the wiring.
   
4. Before installing, spray some silicone grease into the bulb socket.
   
5. Connect the wiring and install the bulb.
   
6. Install the retaining rim and grille.
   
7. Adjustment: turn the adjusting screw (A) for vertical adjustment. Turn the screw (B) for horizontal adjustment.
   

The motor probably went out, or even a just fuse. There is a manual way to raise. There' a adjustment screw on top of the light, turn it until the headlight is up even with the other side. Good luck and keep me posted.

If you park in front of a garage door or building you can line up the lights .right behind the headlight you will see two shafts sticking up just below the support the headlights are attached to. One will adjust lights up &down the other one will adjust side to side.