SOURCE: crankshaft position sensor location
if u pull the battery and battery tray u can easily reach this
SOURCE: 2002 Eclipse
its by your intake manifold on the bottom of the engine block. there is a heat shield covering it which will need to be removed to get to it
SOURCE: crankshaft position sensor location
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
SOURCE: Change a crankshaft position sensor on a 2000 eclipse
Is this a V6 or 4cyl???>>>(V6) This requires removing the Harmonic balancer (crankshaft pulley). Remove (R) front wheel, remove engine splash Guard, Remove crank pulley, remove lower timing belt cover. The Crank sensor is located behind the crank shaft pulley!! I highly recommend having this done by a certified tech, requires special tools. Hopefully this helps!!
2,868 views
Usually answered in minutes!
Pic of sensor location
×