I already tried a 2.2k resistor in place of the censor and did not work.
If you're finding it difficult to service/repair your car, get one of those online manuals. You'll not have to wait for others to
answer, or rely on mechanics and all. Plus I know a website that has very good manuals online, without expiry i.e. for lifetime.
www.reliable-store.com
SOURCE: 98 gmc jimmy front hub
1. Put the vehicle in gear, apply the parking brake and break loose the driveaxle/hub nut with a socket and large breaker bar.
2. Loosen the wheel lug nuts, raise the vehicle and support is securely on lackstands. Remove the wheel. Remove the driveaxle/hub nut.
3. Unbolt the brake caliper and hang it out of the way with wire. Remove the brake disc.
4. On models with four wheel ABS, trace the electrical lead for the wheel speed sensor along the upper control arm, then forward along the frame rail and unplug the electrical connector.
5. Remove the hub assembly-to-steering knuckle bolts. Remove the brake disc shield and wheel speed sensor assembly and set aside.
6. Tap the hub assembly from side-to-side to break it loose from the steering knuckle. Pull the hub assembly off the end of the driveaxle. Wrap the end of the driveaxle with a rag to prevent damaging it. If the hub is stuck on the splines on the end of the driveaxle, use a puller to free it.
7. Installation is reverse of removal process. Be sure to lubricate the driveaxle splines with multi-purpose grease, and tighten all of the fasteners to the proper torque.
SOURCE: how do i bypass security on 98 gmc jimmy 4.3
Hi: Sounds to me like you tried to start the vehicle with something disconnected in the security system. If this is the case the solution is simple. Put key in ignition and turn to the on position, leave on for EXACTLY 30 minutes... then take key out, wait 5 minutes then start vehicle. Hope this helps... please rate suggestion... ty
SOURCE: How do you get to the heater core in a 98 GMC Jimmy?
THE STEERING COLUMN (DO NOT ROTATE THE STEERING WHEEL AFTER THE INTERMEDIATE SHAFT IS REMOVE, YOU WILL BREAK THE SIR COIL), WINDSHIELD MOLDINGS, AND DASH HAVE TO BE REMOVED FIRST. UNDER THE HOOD THE BLOWER RESISTOR, R/H INNER FENDER WELL, HEATER HOSES TO THE HEATER CORE AND SEVERAL NUTS AND BOLTS HOLDING THE HEATER PLENUM TO THE FIRE WALL INCLUDING THE HIDDEN BOLT UNDER THE BLOWER RESISTOR IN THE EVAPORATOR CORE AREA. THEN FINALLY THE BOLTS ON THE INSIDE OF THE TRUCK HOLDING THE PLENUM TO THE FIREWALL.
NO DISRESPECT INTENDED BUT IF YOUR NOT A TALENTED MECHANIC I WOULD FIND ONE OR HIRE ONE THAT CAN DO THE JOB FOR YOU. THIS IS QUITE INVOLVED FOR A NOVICE.
SOURCE: how to disable the DRL on my 05 impala
if you jump the emergency bake light switch located in the back of the e brake pedal the light will stay off.
?€¢
The ambient light sensor indicates daylight.
?€¢
The vehicle is not in the PARK position.
When the above conditions are met, the lamp control module (LCM) supplies battery positive voltage (B+) to the low beam headlamps through CKT 589 (GRY), the DRL resistor, and CKT 12 (TAN). The DRL resistor reduces the voltage supplied by the LCM. The low beam headlamps light at a reduced intensity. The DRL disable if the vehicle is placed in the PARK position. When the ambient light sensor indicates darkness, the low beam headlamps automatically switch from a reduced intensity to a regular intensity.
Lamp Control Module (LCM)
In the center of the IP, below the center heater outlets
49 views
Usually answered in minutes!
×