SOURCE: starter for dodge caravan 2000
DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.
SOURCE: Need install instruction for starter on 2002 Dodge Caravan
This is alittle tricky getting to some of the bolts but its not too hard to do otherwise. 2 bolts hold on the starter IIRC they are 13mm bolts. make sure your battery is dissconected by the black cable. then there will be 2 nuts holding on the starter wires. one will be 8mm and the other 13mm. remove them with care cause the wires may and can break. when you remove starter check wires for corrosion or if they look fraigle. repair them if damaged.
then to put it back in is the same way you took it out. should take about 1.5 hrs total if you have never done it before.
Overall i would say skill level 3/10 only cause its trickey getting to that top bolt sometimes.
good luck,
Michael
SOURCE: manually close to operate liftgate on dodge caravan 2012 rt
There is a sensor in the tailgate that is malfunctioning or the wiring to it is defective. I assume this is still under warranty correct.
Testimonial: "thankss buddy"
1,780 views
Usually answered in minutes!
×