Question about Ford Edge

1 Answer

How to replace a power steering pump in a 2010 ford edge 3.5l

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 6,360 Answers

My personal suggestion would be to go for these repair catalogs. I know this website www.reliable-store.com that i used to get manuals from, and they have all models online.
I also brought for my 1989 BMW, such old model, they had it and it was very good manual. Go ahead, I bet.

Posted on Mar 14, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ilragatzzo78

francisco navarro

  • 241 Answers

SOURCE: Replacing power steering pump 1992 ford tempo

take the belt off.
disconnect the hoses connected to it.
remove the bolts holding the pump.
remove and replace the pump
be sure that you tighten up well the bolts holding the new pump
connect the hoses
put the belt on
refill the pump
turn vehicle on " keep the pump's cap off
refill as needed while turning the wheel from one side to another
" do not overfill, watch out the level marks"
tighten the pump's cap on
ready to roll

Posted on May 16, 2008

Anonymous

SOURCE: Power steering pump leak

replace the pump . the pulley takes a special tool you should be able to rent one at autozone

Posted on Oct 04, 2008

2smart4u

2smart4u

  • 73 Answers

SOURCE: power steering whining and sometimes loss of power steering

steering rack!

Posted on Jun 04, 2009

lordFord

  • 175 Answers

SOURCE: 98 F.Windstar replace power steering pump but still hard to steer

rack and-or pinion... Good thing the 98 is a very good and popular windstar, its not as bad as it sounds.

Posted on Aug 16, 2009

B_o_B_1

  • 270 Answers

SOURCE: power steering pump on a 2001 ford windstar

There is a special tool for that. It should be available at most auto parts stores.

Posted on Oct 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I bleed the power steering pump 2010 chevy traverse?


I would also say make sure your belt to power steering pump is in good shape and adjusted.
Step-by-step DIY directions for properly bleeding the air out of a power steering system
https://www.youtube.com/watch?v=7uS9gvGHH6U
HOW TO REPLACE POWER STEERING PUMP
https://www.youtube.com/watch?v=FD0DLWbtV28

Oct 14, 2018 | 2010 Chevrolet Traverse

Tip

How to remove the inner wheel well liner on the Ford Edge


This video details how to remove the wheel well liner on your Ford Edge to access the power steering, alternator, AC compressor and power steering belt and the serpentine belt.
Removing the inner wheel well cover on 2011 Ford Edge

on Mar 28, 2016 | Ford Cars & Trucks

1 Answer

2010 ford fusion hyprid power steering went out


Power Steering - Hybrid The electric power assist steering system consists of:
  • power steering control module
  • electric motor
  • torque sensor
  • rack-and-pinion steering gear
The electric power steering system provides power steering assist to the driver by replacing the conventional hydraulic valve system with an electric motor coupled to the steering gear. The motor is controlled by an electronic control unit that senses the steering effort through the use of a torque sensor mounted between the steering column shaft and the steering gear. Steering assist is provided in proportion to the steering input effort and vehicle speed.

your best bet would be to have the ford dealer check it out !

Dec 02, 2016 | 2010 Ford Fusion Hybrid

1 Answer

Power steering pump 2007 Ford Edge located where? Can't seem to locate it..need to replace it; 3.5 engine


CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components may result.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .
  1. Using a suitable suction device, siphon the power steering fluid from the power steering fluid reservoir.
  1. Remove the RH inner fender splash shield. For additional information, refer to Section 501-02 .
  1. Using the special tool, disengage the power steering pump belt from the power steering pump pulley and position it aside.
    • Install the removal tool between the belt and the pulley and turn the crankshaft bolt clockwise to disengage the belt.
  1. Remove the 4 bolts and position the driveshaft aside.
  1. Using a suitable jack, support the rear of the subframe.
  1. Remove the 2 nuts, 4 bolts and the subframe support brackets.
  1. Remove the 2 middle subframe nuts.
  1. Lower the rear of the subframe.
  1. Release the clamp and disconnect the power steering supply hose from the power steering pump.
  1. Disconnect the power steering pressure (PSP) switch electrical connector.
  1. Remove the power steering pressure line fitting banjo bolt and disconnect the line from the power steering pump.
    • Discard the 2 seals.
  1. Remove the 3 power steering pump bolts and the power steering pump. This is a job best left to a qualified repair shop !

Jul 26, 2016 | 2007 Ford Edge

2 Answers

Which fuse to change for steering wheel lights and gear shifter lights 2010 ford edge


It's not a fuse , the SJB - smart junction box controls these lights ! This is fords body control module . If the Heater / A/C control panel ,hazard switch ,headlamp switch , message center switch all work, it is not a fuse . The gear shifter I would say the bulb is burnt out . The steering wheel lights could be out because of an open in the clock spring . The clock spring is a device inside the steering column under the steering wheel that keeps your horn , cruise control , radio buttons etc... connected electrically . How cars clock spring works

Feb 04, 2016 | 2010 Ford Edge

1 Answer

When i accelerate I hear a grind noise and when I stop there is a noise in or around the power steering pump


check whether you have no power steering fluid in the pump canister,if you do not,fill it up and start again to see whether the noise gone,If not check your power steering pump serviceability. Might need replacement.

Aug 28, 2014 | 2010 Chrysler Sebring Touring

1 Answer

1993 nissan nx coupepower steering


In relation to these problem there are few solved help links,i suggest you to go through the list and click the required link:-----

Power Steering going out? http://schematicsdiagram.blogspot.in/2012/04/power-steering-going-out.html

---------------
How to Replace power steering pump on Chevy silverado 2500 HD? http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-pump-on.html
--------------- How to replace Power steering rack and pinion gear on Chevy Silverado 2500 HD? http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-rack-and.html
------------- Power Recirculating Ball Steering Gear removal on Chevy silverado 2500 HD? http://technoanswers.blogspot.in/2012/02/power-recirculating-ball-steering-gear.html
----------- Chevy Silverado 2500 HD steering wheel replacing Procedure? http://technoanswers.blogspot.in/2012/02/chevy-silverado-2500-hd-steering-wheel.html
----------- Steering Wheel Locked? http://schematicsdiagram.blogspot.com/2011/12/steering-wheel-locked.html

---------------
How to Remove Power steering Pressure Hose on Dodge Stratus http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-power-steering-pressure.html

------------
How to replace power steering pump on Mitsubishi Diamante?

http://howtobyme.blogspot.com/2012/01/how-to-replace-power-steering-pump-on.html

---------------
How to bleed power steering pump on Toyota? http://repairhelpcenter.blogspot.in/2012/02/how-to-bleed-power-steering-pump-on.html

---------------

----------How to replace power steering pump on Toyota Land cruiser?

http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-power-steering-pump-on.html

-----------
Steering service light ON GMC Sierra Denali?

http://technoanswers.blogspot.in/2012/02/steering-service-light-on-gmc-sierra.html

---------
Steering service light came on 2004 Pontiac Grand Prix

http://technoanswers.blogspot.in/2012/02/on-one-my-pontiac-grand-prix-relatred.html

----------
Check power steering message on Toyota?

http://schematicsdiagram.blogspot.in/2012/02/check-power-steering-message-on-toyota.html

-------
How to remove power steering pulley on 2002 Ford Taurus? http://repairhelpcenter.blogspot.in/2012/03/how-to-remove-power-steering-pulley-on.html
---------1992 Ford Aerostar Power steering and Alternator belt routing diagram? http://carbeltrouting.blogspot.com/2011/12/1992-ford-aerostar-power-steering-and.html

----------------
How to replace Power Steering Pump on Acura Car Models?

Also bleeding:

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-power-steering-pump-on.html

--------------


How to replace Steering Linkage on Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-steering-linkage-on.html

---------------
How to replace power steering pressure hose on mustang? http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-pressure.html

-------------
STEERING SQUEAKS http://alltypesofpartsreplacing.blogspot.com/2012/10/steering-squeaks.html
----------- Steering Column Diagram For 1990 Jeep Wrangler http://schematicsdiagram.blogspot.in/2012/07/steering-column-diagram-for-1990-jeep.html
------------- How to replace Steering Wheel on Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-steering-wheel-on-acura.html

------------
How to replace Power Steering Pump on 1999 Acura TL?

http://howtobyme.blogspot.com/2011/11/how-to-replace-power-steering-pump-on.html

-------------

These details will help.

Thanks.





Nov 23, 2012 | Cars & Trucks

1 Answer

The shift gear light panel is out. Which fuse do I replace?


I'm having the same issue on my 2010 Edge. Coincidently, the lights on the steering wheel controls are out, too. I checked both "Instrument Panel Cluster" fuses (fuse slot numbers 26 and 29), and both are still good. Either there is another fuse, or the bulbs are simply burned out.

May 29, 2012 | 2010 Ford Edge

1 Answer

Belt inst


For the 3.0L Vulcan, you have a tensioner that is located just below the power steering pully. Use a 15mm wrench or the 15mm shallow well socket that comes in a Serpentine Belt tool to push the tensioner toward the rear of the engine compartment. Take the old belt off and route the new belt. The belt begins at the crankshaft pully, goes under and around the a/c compressor, up around the power steering pump, around (with the flat edge) the idler pully, around the alternator, the flat edge then sits against the tensioner and back around to the water pump pully. You should have a belt routing diagram on the underside of the hood just above the serpentine pully assembly.

Jun 23, 2009 | 1999 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...