Question about 2001 Isuzu Rodeo

1 Answer

Bypass fan pully Isuzu Rodeo 2001 - 2001 Isuzu Rodeo

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Isuzu Master
  • 6,360 Answers

You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams, error/fault codes, torque specs, PCV,
owner's/service/repair/parts/maintenance manuals etc everything
this website www.reliable-store.com
it's a very good website for vehicle problems even as old as 1991 ford..

Posted on Mar 19, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: how to check transmission fluid on 2001 isuzu rodeo

There is no dipstick on your auto trans. Checking it is a real PITA The trans pan has 2 plugs in it. The one on the very bottom is the drain. The one in the corner, up higher in a recess is the check/fill plug. To check, the engine must be warm and running, tranny in P. Remove the plug and fluid should dribble out. If it doesn't it's low, fill until it dribbles out, while engine is running. Obviously the truck must be on a lift or up on jackstands.

Posted on Dec 22, 2008

zolo6321

Michael Lewis

  • 7 Answers

SOURCE: MY 2001 ISUZU RODEO

you are having the same problems i'm having, there could be numerous of problem starting from the crankshaft position sensor, o2 sensor, a bad ignition coil. don't make the same mistake i did guessing what is wrong by buying parts here and there. Please TAKE IT TO THE DEALER! let them scan it only telling you what is giving you problems

Posted on Dec 31, 2008

Anonymous

  • 14 Answers

SOURCE: 2001 Isuzu Rodeo 4 cyl 2.2L 2WD that is overheating

check the electric fan conector plug some times is rusti scratchet whit a sharp scruwdriver remove the rusti or dirt on it this happens many times and step two check the relay and thats it (this is the first step a mecanic to search)

Posted on Feb 07, 2010

Anonymous

  • 35 Answers

SOURCE: My Isuzu Rodeo LS V6 2001 ran out of gas and now

get under the truck and hit the tank hard with your hand the pump may be stuck a couple good wacks might work

Posted on Mar 25, 2010

dbridges796

  • 1 Answer

SOURCE: 2001 ISUZU RODEO, FAN SWITCH FOR A/C WORKS

I have the same problem with my 2001 Isuzu Rodeo LS. I took the climate control out of the dash and found that the fan switch had got hot and melted the contacts. I purchased another used unit and installed it. A year later it stopped working again. This time I took it apart and the entire module inside the dash had melted. I am going to splice in a new set of wires to the fan switch, pick up another used climate control unit, and trade off the thing. Its apparent its a defect.

Posted on Sep 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Access to fuel pump on 2000 Isuzu rodeo


The attached videos are for a 2001 but the 2000 will be the same.


2001 Isuzu Rodeo Fuel Pump Replacement Part 1

2001 Isuzu Rodeo Fuel Pump Replacement Part 2


BE CAREFUL!
Semper Fi,
Z

May 01, 2017 | Isuzu Cars & Trucks

1 Answer

My 2001 isuzu rodeo keeps over heating ?


First of all make sure you bleed all the air out properly , air locks can cause the cooling fan not to work . Is the cooling fan working? If all this is ok does the whole system get hot like the radiator and interia heater if not id be looking at the waterpump

Mar 02, 2018 | 2001 Isuzu Rodeo

1 Answer

2001 holden rodeo air conditioning broken, broken fan belt, suitable fanbelt to bypass aircon


Use the same belt as the ac compressor will not work unless you turn it on. Disconnect the wire to the ac pulley clutch and the pulley just becomes an idler and you can get the standard belt anywhere.

Dec 16, 2013 | Cars & Trucks

1 Answer

Is it easy to change the blower fan cage on the 2001 izusa rodeo?


some need to take out glovebox to get to blower fan, then wiring connector, 3 screws and its out.
others you can get without taking glove box out under dash and same as above.

Oct 04, 2011 | 2001 Isuzu Rodeo

1 Answer

My isuzu rodeo overheated the mechanic replaced the fan clutch whats the electric fan behind the radiator for can anyone tell me


when they replace the clutch fan still overheating? if yes, that means he is not a mechanic or he just want to make money, but if no, then they replace it and about the electric fan no electric fan and the clutch fan together

Sep 22, 2011 | 2001 Isuzu Rodeo

2 Answers

2001 Isuzu Rodeo 4 cyl 2.2L 2WD that is overheating


check the electric fan conector plug some times is rusti scratchet whit a sharp scruwdriver remove the rusti or dirt on it this happens many times and step two check the relay and thats it (this is the first step a mecanic to search)

Feb 07, 2010 | 2001 Isuzu Rodeo

1 Answer

2000 isuzu rodeo removal and installation of serpentine belt


All u need to do is put a wrench on the tention pully and turn it clockwise... this will relive the tention take off the old belt ....put on new one. repeat relive pressure again ...slip it on pully... and relese tention..... done! :)

May 16, 2009 | 2000 Isuzu Rodeo

1 Answer

Need diagram to install serpentine belt


Look at the pullies to see if they are smooth or if they have lines on then. The back side of the belt the ( smooth side) goes against the smooth pullies.The side with lines on it goes to the other pullies. Some vehicles have the diagran in the engine compartment. Under the hood or by the top of the radiater.

May 10, 2009 | 2001 Isuzu Rodeo

1 Answer

Serpentine belt install 2001 isuzu rodeo 2wd 4cylinder auto


I believe that you need a 14MM or 15 MM wrench a long one would be the best since the spring is hard to move. There should be a nut on the tensioner pully #6 on the picture below. This is where you need to move the tensioner with one hand and pull the belt off with the other. It might be easier with 2 people. Remember the belt routing it will help when installing the new belt. Good luck.

Jan 09, 2009 | 1998 Isuzu Rodeo

Not finding what you are looking for?
2001 Isuzu Rodeo Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

459 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...