1997 lexus es300 will start an die the small bolt is out the fuel pressure regulator is out fuel is geting to fuel filterhelp

Anand Kumar

• 2035 Answers
• Posted on Jul 08, 2008

SOURCE: 1997 S-10 fuel line/fuel pressure regulator

Please this link :

http://www.autozone.com/addVehicleId,2336303/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800bfe20

SOURCE: Fuel pressure regulator

you will have to remove the upper intake to get to the regulator.

SOURCE: 1997 Grand Prix GTP starts but wont run for more than 5 Sec

is this a supper cahrged grand prix if so check fuel pump resistor located behind right front head light or on fire wall its made of white ceramic has to wires going to it jump the two wire on the connection going to it if it runs longer then 15 min then replace resiustor.

SOURCE: fuel pressure regulator had no vacuum line connected

another engineers wet dream. think of it this way . what is normally in the intake when the engine is running.. answer vacume, hence the regulator gets its vacume without a hose connected to it as its already in a full time vacume chamber.no hose required . ps be carefull to seat the regulator and o rings securely into the housing befor you reattach the secureing metal clip.
good luck chris

SOURCE: How do I change AC blower motor on 1997 Lexus ES300?

THE BLOWER UNIT IS LOCATED IN PASSENGER COMPARTMENT ABOVE THE RIGHT FRONT FOOT WELL.YOU HAVE TO REMOVE THE GLOVE COMPARTMENT LINER.THE GLOVE COMPARTMENT DOOR AND THE AND THE RIGHT LOWER DASH PANEL.THEN YOU CAN REMOVE BLOWER MOTOR SCREWS AND BLOWER MOTOR.

Testimonial: "good instructions!"