I can load a DVD and eject it. It wont play, nothing comes on the screen
SOURCE: Cannot play this disc
remove the cover and see if the dvd run, if not you got a motor problem or a motor drive one,if yes then try cleaning the reading eyes(pickup)by blowing dry air (get a can at radio shack)check for goods, if dosent work, take it to a shop for a repair thats all you can do, is a job for a tech....good luck
SOURCE: cd error message
Try to disconnect battery contacts and connect it back. Check also if there is an emergency opening device. In some model you have a pin hole underneath the cd tray. push a staple tip inside the hole, and this will release the cd.
If the tray still does not open, you may need to have a repairman opening your stereo at your local service point.
Regards
SOURCE: sony mv-900sds overhead dvd
probably you will need to disamble it and remove check button. But the way I need instructions to connect it, I dont have wiring harness to connect it , can you help me with this?
regards
carlos.
SOURCE: 2004 FORD F-150 CD EJECT ERR
I've had this happen once before..CDR's are a little bigger than regular cd's.Sometimes they wont let go at all..You either can undo the battery and then reconnect then it usually automatically ejects or you'll have to manually do it or you can pull the fuse and then put it back in and the same proceedure..
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: 2004 Lexus RX 330 6 pack
The problem may be related to each other. It could be the motor/solenoid that controls the elevator that may have gone bad. Error 4 is a product of the issue. Check for burnt parts like resistors or swollen or leaking parts on the board.
Error 3: Mechanical Malfunction (Replace CD player.)
Error 4: CD Player Overcurrent (Allow CD player to cool and try again.)
520 views
Usually answered in minutes!
×