SOURCE: Front Hub Bearing Torque specs to complete replacement
THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS
SOURCE: what are the front wheel bearing torque specs for
Hi there
i read your report. It 155 to 210 foot lbs. I recommend start off your lowest settings. I wouldn't any higher then 195 foot lbs. hope this info helps you.TY you for writing to fix ya.
Best Regards Richard
SOURCE: how do I change front turn signal light on 2006
If you look at the gap between the fender and the grill on the outside edge of the grill at the level of the turn signal, you will see a grey tab, if you push on this tab while pulling out on the lamp assembly. The whole assembly should swing out and allow access to the bulbs.
Hope this is of some assistance.
Ed
SOURCE: TORQUE SETTING ON FRONT WHEEL BEARING NUT ON 2006
Hello, here is the torque spec for front hub bearing
Strut to Steering Knuckle Bolt and Nut
180 N·m
133 lb ft
Tie Rod Retention Nut
50 N·m
37 lb ft
Wheel Bearing/Hub Mounting Bolt
130 N·m
96 lb ft
Wheel Drive Shaft Spindle Nut
205 N·m
157 lb ft
1,246 views
Usually answered in minutes!
×