SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?
You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett
SOURCE: IAC Valve Location - 1996 Jeep Grand Cherokee
The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body.
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order.
To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.
SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy
it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps
Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "
SOURCE: 2003 Jeep Grand Cherokee Laredo - Code P0456 EVAP leak
open hood and ck for broken vacuum hoses going to the purge valve(2 vacuum ports and a wiring connector)
on the drivers side between airbox and firewall
if good remove driver side rear tire and inspect hoses next to the gas tank and 3rd, the canister is in that wheel well also insp for cracked hoses there also, been working for jeep 12 years i charged people about 1 hour to correct this probem.
Testimonial: "Thanks!"
SOURCE: blower motor only works on high on 98 jeep grand
you need a temp limited switch and for the most part its close to the blower motor has a small screw on each side with a plug in the middle give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your Jeep dealership in the parts department and they be able to show you what i am talking about and print you off pictures and diagrams showing you where it is located wish you the best of luck Michigan Man.
246 views
Usually answered in minutes!
×