Was stalling from a stop. Had 2 seals replaced & oil changed 2 weeks ago. Now jerking from stop when accelerating.
SOURCE: power steering light on 2006 suzuki forenza
Power steering light?? Maybe it's something else.
SOURCE: Stalling and Jerking
I would check the fuel pressure and replace the fuel filter if it hasn't been replaced for awhile. The last 2 fuel filters I changed, the gas coming out of it looked like black ink.
SOURCE: replace front wheel bearing 2006 suzuki forenza
Very easy. Pull the wheel off after lifting the car on the side you're fixing. ;) Then pull the big center nut off the spindle. It's got a safety smash down you will have to lift up that's in a grove on the shaft. You will see this once the wheel is removed. Unbolt that big nut then pull off the brake rotor. The bearings are in the brake rotor and the shaft the rotor was sitting on. Change them both and be back on your way. It's a 20 min job at most for a beginner.
SOURCE: how do i replace my
2006 SUZUKI FORENZA RECALLS/DEFECTS & PROBLEMS
Access the National Highway Traffic Safety database of 2006 SUZUKI FORENZA recalls and defects found on 2006 SUZUKI FORENZA automobiles. The National Highway Traffic Safety administration is authorized to order the 2006 SUZUKI FORENZA manufacturers to recall and repair vehicles or parts of motor vehicle equipment when its investigation indicates that they contain serious safety defects in their structure, or performance.
Check with your loacol suzuki for recall not sure on this part but it is a common problem
Good luck
SOURCE: how to change a crank position sensor on 2006 suzuki forenza
5) Install the rear A/C mountingbracket. Tighten the rear A/C mounting bracket bolts to 35 Nm (26lb-ft).6) Install the A/C compressor. 7) Install the power steering pump. 8) Connect the negative battery cable.
If this helps, please say so! Thanks! :-)
376 views
Usually answered in minutes!
×