Rocker arm torque specs
You need service and repair manual to do the torque setting so go to the given link and get the manual http://toolsnyou.com/
SOURCE: need torque specs
Valve Rocker Arm Bolt 19 N·m + 30° (14 lb ft+ 30°)
A GM dealer shows me another source, which says 32 Nm (24 lb-ft). Not sure which one is right but they screwed up my car.
SOURCE: what is the torque of the rocker arms on alero 2003 3400 engine
14 ft/lbs first pass on all then an additional 30 degrees for all on final pass ..by the way 1 bolt flat to the next bolt flat is 60 degrees so all nuts get half a bolt flat final torque if ya wanna throw caution to the wind torque it to 16 ft lbs and be done with it. lol these specs are from gm ok. good luck and ps the intake pushrods are shorter than the exhaust pushrods and there is no clearance if you get them in wrong an apprentice found this out 3 years ago and a lot of people saw what happens lol..good luck
SOURCE: I have 4.9L6 need torque specs for cylinder head
for cylinder head the torque is : step 1 55 ft-lb, step 2 65 ft-lb, step 3 85 ft-lb. Rocker arm stud nut or bolt is 17 to 23 ft-lb. and valve cover bolt 72 to 108 in-lb.
1,070 views
Usually answered in minutes!
×