What will cause wipers not to work and radio not on 2004 ford freestar

SOURCE: rear wiper stopped working

my 2004 expedition had same problem, if you take apart the shaft that goes thru the glass it will be full of dirt, clean ,lubricate and reinstall, you may have to replace the O-ring on the shaft. a 20 minute job, very easy fix

SOURCE: Front Windsheild Wipers

I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield Printable View (104 KB) Removal

1. Remove the windshield wiper arms.

1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
   Remove the pushpin-type retainers and the cowl panel grille.

1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.

1. If equipped, remove the A/C air inlet filter.

1. Remove the 9 cowl panel bolts and position aside the cowl panel.

1. Disconnect the windshield wiper motor electrical connector.

1. Remove the cowl panel from the vehicle.

1. Remove the 4 bolts and the windshield wiper motor.

1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
   • Tighten to 15 Nm (11 lb-ft).

1. Install the 3 windshield wiper-to-cowl panel bolts.
   • Tighten to 15 Nm (11 lb-ft).

1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.

1. Install the washer hose and grommet in the cowl panel.

1. Install the 9 cowl panel bolts.
   • Tighten to 6 Nm (53 lb-in).

1. If equipped, install the A/C air inlet filter.

1. Position the cowl panel grille in the vehicle and connect the washer hose.

1. Install the pushpins.

1. Install the windshield arms and nuts.
   • Tighten to 27 Nm (20 lb-ft).

1. Cycle and park the windshield wipers to check for correct alignment.

SOURCE: ford freestar 2004 the TRAC OFF message comes

I had the same problem and apparently fixed it by mistake. I replaced the cruise control deactivation switch under the master cylinder, hoping the cruise would be fixed. Some how with that the "trac off" light went out and gave me the ability to turn it on/off from the button again. The part was $30 from the local dealer and easy to replace. Before you run out to replace the switch check the connections on the old one. It plugs in upside down which may accumulate water from puddles and things causing connection issues ( a known problem ).

SOURCE: 2004 Ford Freestar with P0340 Code. What is it

camshaft position sensor

SOURCE: 2004 ford freestar rear hatch latch broken

have you fixed yours yet? mine started doing this last year