SOURCE: reset the engine control light in a 2007 dodge ram
If you cycled the key, and came up with only -------- done then you have no stored/active codes. There is no need to reset the computer, but if you still want to, you can disconnect the battery and touch the positive and negative cables together for 10 seconds. this will discharge the pcm's capacitors, ON A DIESEL BE SURE TO DISCONNECT BOTH BATTERIES!
SOURCE: Electronic stability control
The light may be going off due to system error. Sometimes the traction control circuit or sensor can go faulty. You can go to autozone.com and register for full free online repair manual and more.
SOURCE: EPC, Electronic Stability, Check Engine light
do they stay on longer than a few seconds?
If so, could be a relay, wiring shortage....take it to your local autozone or auto store, normally they will scan your OBD II and see what the codes are...for free....that will help you determine why the check engine light is on.
SOURCE: the electronic stability control light came on is
Hello: To Properly answer your question you will need to have someone check your system for codes, once you know the code and what is creating the failed condition then you can properly diagnose and repair it.
SOURCE: electronic throttle control light comes
Take it to one of the bigger autoparts stores, they will usually scan for free, and determine what trouble code is actually present to verify problem area. The accelerator pedal position sensor is operated by a cable from pedal to APPS, then electronically from there to determine throttle plate positioning. The APPS is located under battery tray, but you can get to it over left front tire. Wait until trouble code is confirmed to determine repair.
978 views
Usually answered in minutes!
×