SOURCE: I try to jump start
hi norwegian
im dave
thats weird
try removing the horn relay first and disabling your alarm if so equipped
is your car manual or automatic?
SOURCE: 1992 mazda 323 Hatchback
Sounds (i can't know for sure unless i can test it) like a bad relay or a connection is broken. Have you checked underneath the hood in the fuse box in the engine bay?
matt
SOURCE: 2002 Mazda 626 Horn Fuse
Under the hood under a black cover. On the underside of the cover it will tell you which fuses are for what.
SOURCE: How to change CV joint mazda 323 mod 1991
In order to change the cv joint, you will need to remove the wheel and the brake caliper and rotor. Raise vehicle on jack stands. Remove the wheel and remove the brake pads and caliper. Tie the caliper up out of the way, do not disconnect the brake line attached. Once the caliper is removed, slide the rotor off. Using the correct size socket, remove the nut in center of hub. Some vehicles have a kotter pin in the shaft just in front of nut. If so, remove pin before nut. Next, you will need to loosen a few bolts that hold the strut to the hub assembly. Once you have hub free from strut, turn the hub either left or right while having someone push in on the cv joint while turning joint left or right. Doing so will allow the joint to slide out of hub. Next, using a pry bar, insert between end of transaxle and transmission and pry out. To install new axle, align the axle with transmission and slide into transmission. Carefully work the other end of axle into the center of the hub assembly. Once you have it in the hub, tap gently with a rubber mallet until you hear it "pop" into transmission. Once it is in transmission, replace the bolts connecting the hub to strut. Replace nut on center or cv joint and tighten just until it seats against the hub...do not overtighten. Replace kotter pin with new pin. Slide the rotor over the studs, replace caliper and brake pads, install wheel and you are done.
365 views
Usually answered in minutes!
×