Cars & Trucks Logo

Related Topics:

G
Gerrit Olivier Posted on Jun 06, 2018

Toyota d4d Hilux 3 litre. When I exhilarate uphill it cuts out. I restart with key and it is ok till next uphill.

5 Related Answers

Anonymous

  • 158 Answers
  • Posted on Aug 28, 2009

SOURCE: fuel tank capacity ?

my research says 80

Ad

Anonymous

  • 277 Answers
  • Posted on Aug 28, 2009

SOURCE: Toyota diesel hilux D4D noisy engine.just

Take the Vehicle back to the Installer/Supplier, for a Free of Charge CHECK and ADVISE under New Engine Warranty. If the OIL PRESSURE is LOW, when starting up from COLD, there is a genuine fault, so do not drive any distance.
Regards,DT

raj somaiya

  • 5370 Answers
  • Posted on Aug 26, 2011

SOURCE: How to change the alternator

Its not very difficult to replace alternator, just few bolts needs to be taken out and alternator can be removed out.For complete procedure with more details , click the link below :--- http://howtobyme.blogspot.com/2011/08/how-to-remove-alternator-on-toyota.html ----------- This will help.Thanks.Helpmech.

johnjohn2

Johnny Brown

  • 5763 Answers
  • Posted on Feb 22, 2012

SOURCE: Toyota hilux 3.0 D4D hard starting showing crankshaft position sensor circuit malfunction code P0335.how do i solve this...?

Check the connection to crank sensor, if wiring is good and connection is clean then replace the crank sensor and reset the code, this is the first step, the computer could be a problem also but most times its the crankshaft sensor. good day

Testimonial: "The connections to the sensor were bad and the hard starting is gone.Thanks JB"

Anonymous

  • 2 Answers
  • Posted on Jul 28, 2012

SOURCE: Toyota hilux d4d 3.0 litre fuel system light reset

Remove the key from the ignition but keep it handy. Important: Disconnect the negative terminal of the battery for longer than 90 seconds to prevent the risk of having the airbags deploy! Replace the diesel filter (Follow the instructions that can be found in Toyota service manuals (search www). Remove the diesel filter sensor cable (the one on top of the filter assembly). Make sure the new O-rings seat properly. Close the filter assembly by turning the locking ring until it clicks. Bleed the filter assembly by pushing the little plunger thing on the top of the assembly until pumping becomes difficult. Connect the negative back onto the battery. Insert the key in the lock and turn until the dashboard warning lamps come on, but do not start the car yet. Within 3 to 60 seconds of doing this re-connect the diesel flter sensor cable. The light should be extinguished. Obviously there could be another problem causing the light to remain on (not flashing - steady on). If the light is flashing, then you have water in the system and should follow the answer supplied elsewhere by someone else to drain the water. Now start the car and enjoy clean diesel fuel driving. You should really not wait for the light to come on steady before chnaging the filter. Some fanatics believe every 10,000km is the longest you should wait, but this depends on fuel quality, low or high sulfur content, etc. Rather do it more frequently than having to buy new injectors.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Tilting backseat

glove box book

Hilux D4d Manual - lux-roc.com

www.lux-roc.com/hilux/hilux-d4d-manual.pdfToyota hilux tiger d4d sport cruiser manual pdf ' pdf owner ... Dec 05, 2014 Download Link: Pdf Download Toyota Hilux 2005-2011 Auto Repair Service Manual, ...
0helpful
1answer

I own toyota hilux 2kd d4d that has a morning cold hard start, after first start all is ok

Excellent answer... short & spot on...
(except YOU didn't mention "OIL CONSUMPTION")

toyota hilux 2kd d4d... Not getting a lot of domestic... (USA)
DIESEL information... here (sorry).

From Bill Boyd here in 1994"

Toyota hilux pick up D4D has hard start in the morning but ok after the...
0helpful
1answer

2010 Toyota hilux d4d 3.0 litre fuel system light reset ?

get the OBD codes read and reset and see if there are any other codes that need looking at , then see if the warning lights come back on , then diagnose further so long vehicle is running OK, check the oil level at least
0helpful
1answer
0helpful
1answer

Toyota 3.0 d4d cylinder head torque

45 nm second stage 65 nm third stage 85 nm +90 degrees +90 degrees from genuine toyota 3.0 hilux d4d 1kd ft workshop manual
0helpful
1answer

Toyota hilux pick up D4D has a hard start in the morning but ok after the first start, kindly advise

Have a compression test done to determine the engine condition. With the hard start and oil usage it points to a worn rings and a lower compression pressure than is required.
1helpful
1answer

How to connect a toyota hilux d4d denso alternator with a 4 pin plug

how to connect a toyota hilux d4d denso alternaton with a 4 pin plug
0helpful
2answers
Not finding what you are looking for?

108 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...