Is it a simple fix buy dropping the trans pan,
These links will help and its the side pan How To Replace Transmission Shift Solenoid On 2005 Chevy Malibu shift solenoids on 4T60 shift solenoids on 4T60
SOURCE: jeep codes location of unit
Got me a complete manual for 199 jeep factory model and found location of each individual unit in question. Manual gives u possible solution to each code and repair and or replace. As a mechanic myself testing, trouble shooting and repair was not that difficult. Shift solenoid was very difficult to get to. Located under the head lamp passenger side.
SOURCE: changed trans fluid and filter and in the process
Try disconnecting battery for about a minute and reconnect.
SOURCE: I have a 1999 Chevy Blazer. A scan reveals code
i had to replace mine. i went to www.rockauto.com and found them for $15 a piece. its actually really easy to do. drop the pan. at the back toward the driveshaft you will see 2 right next to each other. pop out the c clips and it should come right out. reverse those steps to put it back in.
SOURCE: What does code P0753 Shift Solenoid mean?
P0753 means your powertrain computer detects a continuous open, short to ground or short to power in the circuit to your transmission's 1-2 shift solenoid. When the code is active, your transmission runs in a fail safe/limp home mode that only lets certain gear ratios function in the transmission.
The solenoid in your application looks like this
and it is located sometimes on the side of the transmission, but my guess is from the looks of it, it might be found inside the transmission, only accessible with the oil pan removed.
The problem might be the solenoid itself, or the wiring going to the solenoid from the computer that controls the transmission, or the computer itself.
SOURCE: can I change the shift solenoid 1-2 (code P0753)
The shift solinoids are mounted to the valve body which is behind the side cover of the transmission. Usually you have to lower the trans to remove the side cover, which envolves lowering the subframe. If you drop the subframe the steering rack must be disconnected and the engine must be held from above because most of the motor/trans mounts are on the subframe
5,355 views
Usually answered in minutes!
×