Oil light stil flikkering after service how to reset flikkering oil light

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

I assume the buzzer didn't sound. Had the same thing on my 2010. Your diesel filter is dirty. Just replace it.

unhook the battery the postive side and then turn the key on all the way over do that 3 or4 times that shoud reset the computer

turn ignition on (do not start) press accelerator pedal to the floor and hold for 30 seconds, let off for 30 seconds, then turn ignition off allow an additional 30 seconds and start veh. if does'nt work 1st time repeat. this sounds strange but thats how to reset the oil change light.

to reset the light with the doors closed key on press the gas down to the floor 3 times then the light should flash then its reset

check oil straner inside oil pan clean the filter and check if stil. you should replace crank bearing. and con-rod bearing and (oil pump ) you can start by replacing con- rod first .

The full procedure how to reset oil service light Acura MDX. After an oil change, if you like to reset any maintenance oil light for Acura cars. Or any error which appears on the display.
http://resetservicelight.com/reset-oil-service-light-acura-mdx/

Press setup on message center,
press select for system check,
At oil life, press reset

Press odometer reset/adjustment shaft in, hold in and turn key to run position. Keep holding in the reset shaft in for about 30 seconds. release shaft. turn key off. restart car. Service Light should go off in about 5 seconds.

BMW insp. reset -Ingnition OFF (pos 0)
-Press and Hold the trip odometer button while turning key to position 1 (accessory)
-Keep the button depressed (about 5 secs.) imto; upi see "Oil Service" or "Inspeciton" with "Reset" or "Re" in the display
-*Note: ON vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
-Press the button again and hold for approx. 5 secs. imto; :Reset" or "Re flashes
-While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.
Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
2001 up to 2003 for shure don't know about any other models, where i found this it said 2001 to current but not shure when it was posted. Thanks