Do you need the drop fuel tank to change fuel pump in 2007 Suzuki sx4

SOURCE: HOWTO REPLACE FUEL LEVEL SENSOR 2007 ENVOY

you do have to drop the tank

SOURCE: 2007 Suzuki sx4 engine light on after oil changed

The solution is that when the oil filter is removed, oil gets on the O2 sensor and ruins it. Must cover the O2 and that keeps the oil off. To keep the check engine light off, is to replaced the O2 sensor. Problem solve. Later on sx4's they move the O2 in a different spot. I work on Suzuki cars. Don

SOURCE: 2007 suzuki sx4 emission control light on. 17000 miles

My light in my 2007 SX4 just came on. Apparently my oxygen sensor is wrecked... allegedly from oil dropping on it during oil changes. Did the light come on after the most recent oil change?

SOURCE: I have a 2007 suzuki

We have had similar problems with 2007 SX4 for 18 months - engine light on intermittently, sometimes days, sometimes weeks, cruise control disabled when light is on. Suzuki dealer has replaced O2 sensors twice, suggested catalytic converter needs replacement ($1200) but was not certain of cause or remedy. Finally dealer has removed fuel tank and fuel pump to reveal dirty fuel filter. Dealer states dirty fuel as cause which is not their problem as they cannot control fuel quality. Dealer wants $1200 to replace pump but no guarantee it won't occur again with first new tank of fuel! Could make for very expensive driving.

SOURCE: replace water pump on suzuki sx4 2007

Hello J A prohaska.
It doesn't appear to be an easy one to do.
Here is the procedure out of the service manual.

Water Pump Removal and Installation

Removal

1. Disconnect negative (-) cable at battery.
2. Drain coolant.
3. Remove water pump and generator drive belt.
4. Remove front bumper.
5. Remove exhaust manifold.
6. Remove heater pipe (2) from water pump and cylinder block.
7. Remove thermostat
8. Remove water pump (1) from cylinder block (3)

• Use new O-ring when installing.
• Install water pump assembly to cylinder block and tighten bolts to specified torque.

• Refill cooling system
• Verify that there is no coolant leakage at each connection.