SOURCE: how do u change the
Check out this site: " simple.DIY: rid your transmission of notchiness/ Transmission fluid change ..."
http://honda-tech.com/zerothread/1944026
SOURCE: where is the ignition module control located on 1996 ranger 2.3 e
It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.
SOURCE: 1992 Honda Accord (LX) Instrument Cluster Replacement
Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.
SOURCE: where do the ignition control module located in a
The ignition control module (igniter) is inside the distributor, as is the coil on your Accord (1990).
Hope this helps you find it (it looks vaguely like a circuit board with tabs on it).
998 views
Usually answered in minutes!
×