Question about 2004 Isuzu Rodeo

Open Question

What parts of the rear suspension are interchangeable with an 04 Isuzu rodeo

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 7 Answers

SOURCE: can the parts on a 97 isuzu rodeo interchange with

No...the 96-97 don't interchange with the 98-00....and even some of the 98 parts (the tranny for instance) don't fit on the 2000.

Type the part into this website

http://www.car-part.com/index.htm

If it only comes up in the 96-97 and not the 99, it won't fit.

Posted on Feb 09, 2010

Ad

d1ngb4t

  • 2 Answers

SOURCE: what years and models interchange with 1997 isuzu

mostly the 1996 and 1997 are the same, there are some electrical changes.

Posted on Sep 27, 2010

Richard Brooks

  • 252 Answers

SOURCE: 04 rodeo isuzu - the

This is normally the blower motor resistor rather than the speed control...To test the resistor it is located at blower motor..normally no less than 4 wires are in the connector that plugs into resistor...unplug resistor connector,turn ignition on...turn speed control on at all speeds while checking connector at all wire ends of connector...check each wire at all speeds If you have power at all speeds then the resistor has failed...If you dont have power but at only 1 or 2 then the speed control switch has came slightly disconnected at back of switch or the control switch has failed.
HOPE THIS WILL HELP....................METALPOET

Posted on Feb 28, 2011

zappanut

ZappaNut

  • 959 Answers

SOURCE: want to interchange rear end on a 1997 5 speed

Hey there Alex,
I am going to say no...
I did check the interchange and Hollander Interchange says no.
Reason being , the carriers are different.
I am assuming you are working on a 2wd , or you would have mentioned the front axle assembly as well.

Here are the options for the '97 ;
96-97 only
disc brakes (6 cyl), (4.30 ratio, 43/10 teeth, S7C), 3 sensor ABS (sensor in pumpkin)
disc brakes (6 cyl), (4.30 ratio, 43/10 teeth, S7C), 4 sensor ABS (sensors in axle tubes)
drum brakes (4 cyl), (4.56 ratio, 41/9 teeth, HC6)

and here are the options for the '98;
1998 and 1999 only
4x2 (drum brakes), 3.73 ratio (41/11 teeth, 6NW)
4x2 (drum brakes), 4.56 ratio (41/9 teeth, HC6)
4x2 (drum brakes), 4.10 ratio (41/10 teeth, GT5)
4x2 (drum brakes), 4.30 ratio (43/10 teeth, S7C)
4x2 (drum brakes), 4.78 ratio (43/9 teeth, S2J)

Posted on Sep 30, 2011

teds_repairs

teds repairs

  • 2101 Answers

SOURCE: what year will interchange 1996 Isuzu rodeo 3.2 motor

it is 1996 and 1997 only

Posted on Dec 11, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a 1999 isuzu rodeo sport 2wd v6 auto trans idle air replacement valve interchangeable with a 1999 isuzu amigo sport


double posted why, ? please add to 1 post,
by edits or comments, please'
there are 3 , v6 engines, you never said which
why ask us, about parts, we dont sell parts
and would have to read the same books on parts as you
why ask use to do that.?
here is the list
USA only, RODEO, prime examples. the GAS v6 engines. 3.1L 3.2L 6vd1 SOHC, one cam per head, then the optional... 6vd1w DOHC, 2 cams in one head, w = DOHC optioned heads, then came... 3.5L (a stroked out, 3.2L.) 6ve1 are all DOHC engines. and have 24 valves. (6x4) with 2 rear cam sensor, used for VVT and spark both,
the engines must match ,to mix parts

here im at isuzu.com parts page
note it changed on August 99, mfg build dates. so.....
tricky
this will not cause low MPG
it will cause idle controls to be dead.
why not post all symptoms, first. and stop guessing?

iac-oxkqb5rw1cdtny1acrjczugf-5-0.png

Feb 12, 2017 | 1999 Isuzu Amigo

1 Answer

Will any parts interchange from a 2001 isuzu rodeo? body,mechanical,etc onto my 1995 isuzu rodeo as I have found a parts vehicle


Contact a local salvage yard they have a cross reference catalog. But if you ask me the answer is no.

Apr 29, 2016 | 1995 Isuzu Rodeo

1 Answer

Are the block and heads the same in an 98 Isuzu Rodeo 3.2 and a 2001 Isuzu Rodeo 3.2?


3 places you can get the answer.
1) dealer parts department
2) a salvage yard or parts store like auto zone or advanced auto.
3) a machine shop that does head repair. I would start here and have the donor head checked before i installed it and then found out it wasn't flat.

May 18, 2014 | Isuzu Rodeo Cars & Trucks

2 Answers

What transfer case control module will fit a 2004 isuzu rodeo?


Try going to www.car-part.com They have a built in Hollander interchange, if there is anything out there that will interchange it will let you know.

Apr 06, 2014 | 2004 Isuzu Rodeo

1 Answer

Interchangeable parts


as iam aware of it all from doors , bonnet , apron should go on no problem in aust the face lift was made in 98 I think it was still considered a TF rodeo until some time in 2002. so I don't think you will have any problems at all

Mar 03, 2014 | Isuzu Rodeo Cars & Trucks

1 Answer

Want to interchange rear end on a 1997 5 speed isuzu rodeo. Can i use a rear end from a 1998 3.2 rear end


Hey there Alex,
I am going to say no...
I did check the interchange and Hollander Interchange says no.
Reason being , the carriers are different.
I am assuming you are working on a 2wd , or you would have mentioned the front axle assembly as well.

Here are the options for the '97 ;
96-97 only
disc brakes (6 cyl), (4.30 ratio, 43/10 teeth, S7C), 3 sensor ABS (sensor in pumpkin)
disc brakes (6 cyl), (4.30 ratio, 43/10 teeth, S7C), 4 sensor ABS (sensors in axle tubes)
drum brakes (4 cyl), (4.56 ratio, 41/9 teeth, HC6)

and here are the options for the '98;
1998 and 1999 only
4x2 (drum brakes), 3.73 ratio (41/11 teeth, 6NW)
4x2 (drum brakes), 4.56 ratio (41/9 teeth, HC6)
4x2 (drum brakes), 4.10 ratio (41/10 teeth, GT5)
4x2 (drum brakes), 4.30 ratio (43/10 teeth, S7C)
4x2 (drum brakes), 4.78 ratio (43/9 teeth, S2J)

Sep 30, 2011 | 1997 Isuzu Rodeo

1 Answer

Can the parts on a 97 isuzu rodeo interchange with a 99 honda passport


No...the 96-97 don't interchange with the 98-00....and even some of the 98 parts (the tranny for instance) don't fit on the 2000.

Type the part into this website

http://www.car-part.com/index.htm

If it only comes up in the 96-97 and not the 99, it won't fit.

Feb 09, 2010 | 1997 Isuzu Rodeo

2 Answers

1995-96 Isuzu Rodeo transmission swapable?


No they are not compatible. They changed the crank between 95 and 96. I have a 96 that needed an engine swap and the dealer that I bought it from was paying for the engine, he bought a 95 engine and after a month of trying the mechanic said no way no how, the crank between the two is different.

Aug 20, 2009 | Isuzu Rodeo Cars & Trucks

Not finding what you are looking for?
2004 Isuzu Rodeo Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

459 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...