None of the door power lock's work ? Not from any switch ? F32 - 15 amp fuse location - body control module (BCM) . Probably not a fuse issue , door locks are controlled by the BCM controlling relay's located inside the BCM . This relay's are PCB - printed circuit board relay's , non serviceable . Your best bet , take it to a qualified repair shop .
Power Locks
The Body Control Module (BCM) monitors the door lock control switches. When the BCM receives an unlock/lock command from either door lock control switch, the BCM energizes a relay (internal to the BCM ) to supply the correct power and grounds for the door lock actuators.
Remote Keyless Entry (RKE)
The Remote Keyless Entry (RKE) feature is controlled by BCM . The BCM receives the RKE inputs from the Tire Pressure Monitor (TPM) module over the Medium Speed Controller Area Network (MS-CAN) . When any RKE transmitter button is pressed, the signal is received by the TPM module internal antenna. The TPM module then filters the RKE signal received to make sure it is a programmed transmitter. If the signal received is from a programmed transmitter, the TPM module sends the RKE command to the BCMover the MS-CAN . The BCM then interprets the RKE command and activates the corresponding output.
The BCM requests the illuminated entry feature to turn the interior lamps on when an unlock command is received. If a lock command is received, the illuminated entry feature turns off. The BCM then supplies voltage to the appropriate door lock actuator(s) to lock or unlock the doors. The RKE transmitter can also be used to activate the panic alarm. On vehicles with memory, the RKE transmitter also causes the BCM to send a MS-CAN message to the Driver Seat Module (DSM) to activate all memory features to the positions associated with the RKE transmitter being used.
Visual Inspection Chart
Mechanical
Electrical
Do you know what DTC'S are ?
DTC Charts
GO to Pinpoint Test H.B1218: 00Transmitter Identification Code: No Sub Type InformationGO to Pinpoint Test H.B121A: 11Keypad Illumination Output: Circuit Short to GroundGO to Pinpoint Test G.B121B: 01Keypad Input Switch: General Electrical FailureGO to Pinpoint Test F.B126A: 01Drivers Door Interior Lock Switch: General Electrical FailureGO to Pinpoint Test E.B130D: 00Memory Full for Integrated Key Programming: No Sub Type InformationThe maximum amount of IKTs (4) have been programmed into the BCM . Obtain all the customer's IKTs . Erase all the IKTs and program a maximum of 4.All other DTCs-REFER to the Diagnostic Trouble Code (DTC) Chart in Section 419-10.
SOURCE: i have a grand voyager
dont go through all the hassles of removing the door trim just take the terminal off the battery for about a minute then reconect again worked on mine good luck
SOURCE: I have 2001 ford focus se, 130,000 my power locks
yes there is if you drop down the glove box lid and remove the bolts holding the fuse box. unclip the fues box and pull it down. turn the fuse box around and there is a fuse on the back (i thing its a 15amp)
this is the other fuse for the central locking.
please let me know if this helps
cheers
big mike :)
SOURCE: c240 mercedes key wont turn seems locked
I have a 2001 C240 with the same issue. I removed the positive battery cable from the battery and kept it off for 30 seconds then replaced it. Everything was reset and the key worked.
SOURCE: My Porsche Cayenne S Key fob no longer unlocks the Door
unlock the door then press the lock button on remote and hold down for 20/30 secs.manual does say hold button.....
SOURCE: my Porsche Key fob no longer unlocks the doors
Insert key into door barrel or ignition lock and turn key, whilst doing this press the unlock/lock button, the led on the dash should flash to indicate this has initialised the key to the car, then remove key and test operation of remote. If this fails then a new remote plus coding to the car by your dealership is needed
If
the remote s faulty then key fob will not get programmed.
Insert
the key in ignition. Turn the key to on position, and cycle the key three times
off-on-off-on-off-on. Then with the key fob remote select your remote and then
try to operate the vehicle with remote.
These
are just the basic procedure, but sometimes it will not help.
On
that case dealer is the only option.
---------
There
are few much related troubleshooting links mentioned below for remote key fob reprogramming.
I suggest you to go through the list and click the link below to go through its
details and procedure: -------
http://technoanswers.blogspot.in/2012/02/theft-indicator-not-letting-car-to.html
-------------
http://whatisbyme.blogspot.in/2012/05/2009-toyota-highlander-smart-key-not.html
----------
-----------
http://whoisbyme.blogspot.in/2012/07/pin-that-holds-flick-key-part-to-key-fob.html
-------------
http://technoanswers.blogspot.in/2012/04/2006-toyota-hilux-programming-new-key.html
----------
http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html
----------
http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html
----------
http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
-----------
http://technoanswers.blogspot.com/2011/12/audi-a8-key-fob-programming.html
----------------
http://technoanswers.blogspot.com/2011/12/olds-aurora-key-fob-reprogramming.html
-------------
http://technoanswers.blogspot.com/2011/12/buick-lesabre-key-fob-reprogramming.html
---------------
http://technoanswers.blogspot.in/2012/01/keyfob-remote-not-working-on-2003-ford.html
-----------
http://technoanswers.blogspot.in/2012/02/key-will-open-doors-but-not-start-on.html
------------
-----------
http://technoanswers.blogspot.in/2012/02/key-fob-will-not-lock-and-unlock-doors.html
-------------
-----------
-----------
http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html
--------------
These
details will help.
Thanks.
KEYFOB PROGRAMMING
If
the remote s faulty then key fob will not get programmed.
Insert
the key in ignition. Turn the key to on position, and cycle the key three times
off-on-off-on-off-on. Then with the key fob remote select your remote and then
try to operate the vehicle with remote.
These
are just the basic procedure, but sometimes it will not help.
On
that case dealer is the only option.
---------
There
are few much related troubleshooting links mentioned below for remote key fob reprogramming.
I suggest you to go through the list and click the link below to go through its
details and procedure: -------
http://whatisbyme.blogspot.in/2012/05/2009-toyota-highlander-smart-key-not.html
----------
-----------
http://whoisbyme.blogspot.in/2012/07/pin-that-holds-flick-key-part-to-key-fob.html
-------------
http://technoanswers.blogspot.in/2012/04/2006-toyota-hilux-programming-new-key.html
----------
http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html
----------
http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html
----------
http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
-----------
http://technoanswers.blogspot.com/2011/12/audi-a8-key-fob-programming.html
----------------
http://technoanswers.blogspot.com/2011/12/olds-aurora-key-fob-reprogramming.html
-------------
http://technoanswers.blogspot.com/2011/12/buick-lesabre-key-fob-reprogramming.html
---------------
http://technoanswers.blogspot.in/2012/01/keyfob-remote-not-working-on-2003-ford.html
-----------
http://technoanswers.blogspot.in/2012/02/key-will-open-doors-but-not-start-on.html
------------
-----------
http://technoanswers.blogspot.in/2012/02/key-fob-will-not-lock-and-unlock-doors.html
-------------
-----------
-----------
http://technoanswers.blogspot.in/2012/02/theft-indicator-not-letting-car-to.html
-------------
http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html
--------------
These
details will help.
Thanks.
http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html
----------After getting car
washed, check engine light is ON and key less entry not working, tried
reprogramming. Also car shows fuel pressure?
http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
-----------Audi A8 Key Fob Programming?
http://technoanswers.blogspot.com/2011/12/audi-a8-key-fob-programming.html
----------------
Oldsmobile Aurora Key Fob Reprogramming?
http://technoanswers.blogspot.com/2011/12/olds-aurora-key-fob-reprogramming.html
-------------
Buick Lesabre Key Fob Reprogramming?
http://technoanswers.blogspot.com/2011/12/buick-lesabre-key-fob-reprogramming.html
---------------
Keyfob remote not working on 2003 Ford E350 Econoline?
http://technoanswers.blogspot.in/2012/01/keyfob-remote-not-working-on-2003-ford.html
-----------
KeyFob will open the doors but not start on BMW?
http://technoanswers.blogspot.in/2012/02/key-will-open-doors-but-not-start-on.html
------------
Mitsubishi Car Key Not getting detected after replacing ECM
http://repairhelpcenter.blogspot.com/2012/11/mitsubishi-car-key-not-getting-detected.html
-----------
Key Fob will not lock and unlock doors?
http://technoanswers.blogspot.in/2012/02/key-fob-will-not-lock-and-unlock-doors.html
-------------
2000 Jeep Cherokee Limited: KeyFob Remote Not
Working?
http://schematicsdiagram.blogspot.in/2012/06/2000-jeep-cherokee-limited-keyfob.html
-----------
Chevrolet Malibu: Key Stuck in ON position?
http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html
-----------
Theft indicator not letting car to start?
http://technoanswers.blogspot.in/2012/02/theft-indicator-not-letting-car-to.html
-------------
2012 Dodge Ram: Ignition Key will not
release?
http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html
--------------
These details will help.Thanks.
2,186 views
Usually answered in minutes!
×