Very likely that the 3-4 clutch pack piston seal has blown out. Will need to be taken apart and repaired before too much damage occurs. Drive it in manual 2 to get where you are going. Do NOT put it in 3 or OD and do not let it try to go into 3rd again until it is rebuilt. Sorry for the bad news. This is a common problem.
SOURCE: 2003 chevy silverado will not shift into drive or overdrive.
transmission shift solenoid is stuck open this is a common vehicle issue in automatics and not particular to any make or model vehicle 15 dollar part and arm and leg for labor if taken in
heres an idea to try
take out the transmission filter and replace with new one make sure to take not of any metal debry in trans pan this indicates the trans had sheered its gears down and a trans rebuild is needed
the transfilter needs to be changed at a certain milage interval they can get clogged up
there is a kit you buy for your truck at any parts store
its an easy change hour of time unbolt trans pan unbolt trans filter and put new one in
kit comes with new seals less than an hour you can do it yourself
to overdrive you would feel a difference in shift badley if it was that something to keep in mind
SOURCE: transmission
hello, your truck will not shift from second to third . If it wont shift to third it is going to need new clutchs or seals installed in the transmission that is a common problem with the 4L60e transmission.
SOURCE: my 97 chevy blazer won't shift past 3rd gear
Drop the pan, odds are the shift solenoid is out, its located at the front of the trans on the driver side. I'm sure your check engine light is on that will comment about the timing/shift solenoid being bad. I had the same problem with mine. The solenoid had plastic coming out of the inside. To remove it you'll find a small C clip holding it in, just take a small screw driver and pull the clip out. The part cost me like $36 from my local dealership. And its a longer solenoid. I believe its the 3-2 downshift solenoid. I do have the part number if you need it.
Testimonial: "Thank you so much. I actually thought this was the problem, but i didn't know. Thanks again!! send me the part number"
SOURCE: my chevy silverado 2000 tow haul wont work, light
check all your fuses. If your lucky you might find one the is blown and could be related If not fuse related then you need to remove the platic steering column cover. Under there at the end of the shift lever you will find two small wires that are for the tow haul button. These wires get brittle and break over time from shift level movement it seems. You will have to repair the broken wire and you should be good to go!
4,636 views
Usually answered in minutes!
×