SOURCE: Serious understeer with 96 Dodge Ram 3500 Dually
Are the tie rod ends tight? Is the trac bar (frame end) tight? The steering boxes on these trucks require more input that a 1/2 ton truck or a car. How is the alignment? The caster on these should be set to about 5 degrees, the original specs allow a lot of wandering.
SOURCE: serpentine belt diagram 2007 dodge 5.9 3500
get the belt routing from the local dealer.
they will not charge alot of money for a reprint from the factory service manual.
also
dayco belts come with the belt routing on the box.
SOURCE: rear axle oil seal location for chevy 3500 dually
Here is a picture step by step guide from autozone:
http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapterTitle=Rear+Axle&partName=Drive+Train&pageId=0900c1528008f4d4&subChapterTitle=Axle+Shaft%2C+Bearing%2C+And+Seal&partId=0900c1528008f406
SOURCE: i need a rear brake diagram for a 89 chevy 3500 4x4
Try this website :-http://www.compnine.com/index I used it to fit a parking brake to our 1999 sierra that had them missing
SOURCE: how to remove the rear brake rotor on a 2006 dodge
Single rear wheel - Remove both caliper bolts.. remove caliper and pads.. remove rotor.. they are usually rusted on pretty good.
Rear Dually- the rear rotors are mounted with the hub assembly.. you must first remove the rear axles.. then remove nut holding load on bearings.. then the rotor and hub assembly will come off as one unit.. removed rotor from hub..
62 views
Usually answered in minutes!
×