Step1 in the service manual states
check levels first
then make sure the shift linkage is good end to end,
then scan the pcm for TCM errors. using a real scan tool OBD2 USA
and more, lots more, check fuses?
to the service manual pump; pressure tests PRNDL pressures each?
SOURCE: 1986 dodge ram 150 tranny problem
Sorry this is not an easy fix the clutch packs in the transmission are slipping, usually caused by wear, but the hydraulic pump is probably getting week. As the oil warms up the oil gets thinner and the hydraulic pressure decreases. Times for a overhaul of the transmission, and if the torque converter can not be flushed a new torque converter is recommended. You may get lucky buy changing the fluid several times, but if the transmission is 22 years old it may not help.
SOURCE: 98 dodge ram 1500 4x2 ...5.2l,stalls immediatly
you might have a bad torque converter lockup switch
SOURCE: transmission 98 dodge ram van 1500 5.2 rear drive fails to engage
Change your transmission filter. You're probably not getting enough pressure to get the boost valve to kick the reverse solenoid. I would have the whole transmission flushed and filled if it's starting to act weird. Good luck.
SOURCE: 2001 dodge ram won't go into reverse
sorry but i dont have good news for you, this is a common problem with the dodge, what has happened is there is a drive drum inside the transmission that has a reverse drive gear inside it this has most likely broken, you will need to remove the transmission oil pan and look for junk inside the pan if you find more then a teespoon of metel in the pan or any brass you will need to replace the transmission......sorry
116 views
Usually answered in minutes!
×