1998 Dodge Caravan Logo

Related Topics:

K
Kathy Rodgers Newberry Posted on Aug 20, 2018

HI Fixya, My husband just put a water pump on my 1998 Dodge Caravan 2.4 now it will not stay running when you mash on the brakes it goes dead please help as soon as possible Thank you!

Whan cranking the car it cranks up sludgiest and once it's cranked and I mash on the brakes it goes dead.

1 Answer

gckcmc

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 18 Answers
  • Posted on Nov 05, 2018
gckcmc
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Problem Solver:

An expert who has answered 5 questions.

Joined: Mar 08, 2009
Answers
18
Questions
0
Helped
5317
Points
45

Does it stay running if you don’t press the brakes?

Testimonial: "No it doesn't"

5 Related Answers

Anonymous

  • 39 Answers
  • Posted on Sep 25, 2008

SOURCE: 1997 Dodge caravan crank position sensor

it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.

Ad

Anonymous

  • 19 Answers
  • Posted on Jan 16, 2009

SOURCE: 1996 Dodge Caravan with a 3.0L . Long cranking time before starti

You need to do a fuel pressure check.. You will need a special fuel gauge and the appropriate fittings and adapters are needed to properly test the fuel pressure.

1. Relieve the fuel pressure.
Remove the fuel pump relay form the Power Distribution Center (PDC) Start the engine and run until it stalls. attempt restating the engine until it will no longer run. Turn the ignition key off. Disconnect the cable from the negative battery terminal. Replace the fuel pump relay in the PDC. Any if you get any trouble codes at this time you will need to see a shop to have them cleared.

2. Disconnect the quick-connect fuel line fitting fuel gauge into the fuel line using the appropriate T-fitting and adapters.

3. Start the engine and check the pressure on the gauge, your reading should be 49 PSI with the pressure with the engine idling.

4. if the fuel pressure is not 49 PSI:
1) if fuel pressure is higher you could have a pinched of clogged fuel return hose of pipe. if the line is not obstructed check the fuel pressure regulator.
2) if fuel pressure is lower check the fuel filter, look for a pinched of clogged fuel hose between the tank and the fuel rail. check the pressure regulator for malfunctions. Look for leaks in the fuel line.

Hope this helps.


Anonymous

  • 12 Answers
  • Posted on Feb 26, 2009

SOURCE: CAR CUTS OFF WHEN PUT IN GEAR

if it is standerd then it is most likely your lutch try to keep your r.p.ms at the owest point you can before shifting if it is automatic it could be the pressure plate but im not an expert with automatics{yet again the change them so often that nobody really is}

Anonymous

  • 112 Answers
  • Posted on May 27, 2009

SOURCE: good fuel pump, engine turns over but wont crank.

if u pour fuel in the throttle body n cranks then goes dead u may want to check your fuel injectors see if they're actually working , u say your fuel pump is good maybe not the injectors

Anonymous

  • 395 Answers
  • Posted on May 05, 2010

SOURCE: my lexus ls400 cranks over but wont start also the car goes dead

this could be a starter or the enigtion swicth yes if you crank the key to long it will kill the battery.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Why won't my ignition turn on my 1998 dodge caravan

More details please, is enough gas? Is the starter running? And more...
0helpful
1answer

My 1999 dodge caravan was smoking from under the right side of the hood

if you lost antifreeze its the water pump

if it smelled rely strange and funky you could have a brake caliper binding causing brake pads to stay applied need more info to ferther help
0helpful
1answer

1998 Dodge 3.3ltr grand caravan overheats.I have repaced water pump,Thermostat,Had cracked head and replaced both of them with new ones,Replaces fans,replaced fan relay,All hoses,Radiator.When i start...

You would need to figure out if it is a cooling problem or something producing extra heat in the engine.
Is the radiator fan pulling enough air thru the condenser and radiator ?
Is the fan coming on and also when the ac is on and when the engine reaches 220 degrees ?
Is it possible the exhaust has a restriction somewhere ?
0helpful
1answer

I got a water leak coming from the front of the engine can not locate the water pump can you please tell me what is my problem it is 1998 dodge caravan 3.0Liter v6

your on the right track it most likely is the water pump, the pump is behind the timing cover on the 3.0L V6 you have to remove the cover and the timing belt in order to replace the pump....HAVE FUN
4helpful
1answer

I have a dodge caravan that has the ABS and the BRAKE light on the pedal is rally hard but it goes away once in a while for like a day and all over again

Dodge used an ABS system for 2 years that didn't have a vacuum booster. Instead it used ABS pressure from the pump motor for the power brakes. This is the system you have. The ABS pump is mounted on top of the transmission. Is the pump running when the pedal is hard to push? Sometimes the pressure sensor in the ABS module will go bad and the pump won't run. You will get a hard pedal and the ABS light and the BRAKE lights will be on. The code in the ABS control module will be LOW BRAKE ACCUMULATOR PRESSURE.
1helpful
1answer
0helpful
2answers

How do i fix a water pump in a 96 dodge caravan

You'll need to remove the serpintine belt, once removed you'll need to take the pulley from the water pump, I believe three bolts, 10MM. After this is removed you'll be able to see the bolts holding the pump in place. I believe there are 5 or 6 of them, if my memory serves they are 8MM.

Please let me know if this had assisted you,

Thanks,
Tom
2helpful
1answer

Serpentine belt slipped off. 1998 Dodge Gran Caravan 3.0 litre 6 cylinder

On this particular model of the 1998 Dodge Grand Caravan I determined that the upper hose from the water pump had slipped off and anti-freeze squirted on the serpentine belt causing it to slip off. Once the belt gets slick it never stays on. I replaced the belt by loosing the tensioner which is the idler pulley located in the center of the configuration, A big thanks to user motor1258for the configuration diagram.
0helpful
2answers

Both wheels do not rotate together

there may be air in the line or the caliper could be faulty try bleeding the brakes
Not finding what you are looking for?

65 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...