There is a tiny button under the dash that needs to be held down to reset it. There are a couple of ways to reset them depending on the year model. I think this youtube vid relates to your car (not the best vid but should help) -
Acura Integra MAINT REQD light reset GS GSR LS
SOURCE: Maint REQD lighting in the dashboard
It means: (Maintenance Required) get your owner's manual and match ur milage to what your owner's manuel's service requirements recomend..
SOURCE: "maint reqd".
That is for oil changes. It come on when the oil change is due.
When you have your oil change done, the lube tech should reset the this light every time.
If you need help resetting the light, let me know.
SOURCE: Main relay location
The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release.
rate this solution fixya.
Diagram below:-
Acura Main Relay location and removal procedures.
Integra
EFI Main Relay for:
The main relay is located behind left side of the dash and above and
behind the fusebox and above the hood release. The First generation
Legend main relay location is between the steering column and the fuse
box. It's deep in there. There was a little difficulty drawing the
relay so it's actually very deep in there. There is a device (a relay)
blocking
the main relay. You will need to remove it to get a view of the main
relay. The removal procedure is the about the same as the Accord's
procedure.
Legend, 96-98 Acura TL main relay
Acura Integra 98-01 main relay location:
Locating the main relay using your ears and fingers:
Steps:
1. Turn the ignition to ON. You should hear two clicks (a thousand
of a second apart) under the left or right side of the dash board. One
click is for the ECU/Injectors the other is for the fuel pump. At this
moment the check engine light should come on.
2. Listen carefully at the moment the clicks engage (usually somewhere
underneath the dashboard.) Reach in and touch the main relay.
3. 2 seconds later you should feel a click if the main relay is at
least working or wait until it works. At this moment the check engine
light should go out.
4. Turn the ignition to start and you should feel a click, turn engine off you should feel another click.
5. Most main relays should have seven terminals. Please check if the location is already listed below.
How do I get the main relay out?
Steps: See four ways below so you can get it out. First you have to reach
high up in there and do all this with one hand and a flashlight.
A. Unbolt the bolt using a 10mm socket (picture A) or
Ab. Unclip the clip from the steel tab and slide it apart (picture A) or
B. Separate the steel tab from the plastic case (picture B) with a
large flat screw driver
jam and twist between the plastic case and the tab or
C. Disconnect the negative battery terminal. Unclip two clips I pointed with two arrows (picture C, or below)
with a small flat head screw driver or with a strong thumb and then yank it out (D.)
This is the preferred choice by many. Mechanics prefer choice A and maybe
B. See detailed relay circuit photo.
SOURCE: reset my maint reqd light
watch this free video instructions on how to reset your maint reqd light if video dosent work go to www.vehix411.com
SOURCE: reset the maint reqd light after an oil change
you put your odometer on trip a or b or just the regular mileage sorry they changed it a couple times anyway you hold the odom reset button with key off turn key to on position you will see several lines that will count down once they count down on odom it will go back to mileage and it should be reset
191 views
Usually answered in minutes!
×